MODIFYING A LIBRARY. BEN-RI Hydra II S48-3000, Hydra II S48-6000, Hydra II Series, Hydra II S24-6000

8-14 SUBMASTERS

8.3 MODIFYING SUBMASTERS

The modification of a cue or group loaded in a Submaster can be done directly over the Submaster:

{Modify in the editor}

You can use this method independently of the output level of the Submaster (including at its 0%). If the

Submaster is at 100% or 0% the modifications will be done with the absolute values, but if the Submaster is not at 100% or 0% the modifications will be done relatively. Example - Submaster 1 has a group with the channels 1 & 5 at 80%...

Submaster Output

{modification

}

Modified output Group

(0%)

Ch6@30,

Ch7@60

Ch1@80,

Ch5@80

Ch6@30

Ch7@60

Ch1@40

Ch5@40

Ch6@30,

Ch7@60 *

Ch1@40,

Ch5@40

Ch6@30,

Ch7@50

Ch1@80,

Ch5@80

Ch6@60

Ch7@FF (50%)

(100%)

Ch1@80

Ch5@80

Ch6@30,

Ch7@60

Ch1@80,

Ch5@FF

Ch6@30,

Ch7@60

Ch1@80,

Ch5@80

Ch6@30

Ch7@60

60* Levels of dimmer/channel, greater that the Submaster level, are sutured levels. They are recorded at FF.

After the modification they are recalculated for the Submaster output.

If these modifications are done in Blind , , the modification is not active until the Submaster arrives its zero; ie until Submaster is activated the next time.

** More about modifications in Chapter 6 - Groups & Cues)