Finish the Radio Installation. Tower Hobbies Ultimate, Ultimate Bipe GP/EP ARF

the receiver where desired. Use tape to hold the receiver antennas perpendicular to each other as specifi ed in the instructions that came with your radio control system.

❏

10. If you’ve mounted an electric motor with the adjustable brushless motor mount, move the motor forward the distance of the desired spinner gap. Test-mount the cowl to the fuselage with four M2.6 x 8 washer-head wood screws.

❏

11. If you’ve mounted a glow engine, use a Dremel 569 and/ or 570 Dremel

grout removal bit

and a sanding drum to cut holes in the cowl for the glow plug igniter, muffler, needle valve and fueling/defueling line.

Caution:

Be certain to wear eye and respiratory protection when cutting fi berglass.

Finish the Radio Installation

Mount the receiver battery and on/off switch (if used) and the receiver where practical and convenient. Review the following steps to see the options. An optional

universal mounting tray

is included for the receiver and/or receiver battery and another optional

battery tray

is also included to mount a receiver battery in the nose. If you’ve installed an electric motor, the receiver should be mounted on the

bottom

of the servo tray in the wing saddle so as not to interfere with installation/removal of the battery tray.

❏

2. If using the optional

universal mounting tray

, glue the ½" x ½" x ¼" [13 x 13 x 6mm] hardwood

tray mount blocks

into position where shown. Fit the tray and drill

1/16" [1.6mm] holes and mount the tray with four M2.3 x 8 washer-head screws.

❏

1. If not using the universal mounting tray, use doublesided foam adhesive tape or adhesive-back Velcro to mount

22