Attach the Belly Pan. Tower Hobbies Ultimate, Ultimate Bipe GP/EP ARF

Attach the Belly Pan

❏

1. Mount the bottom wing to the fuselage with the included

¼ - 20 x 1" nylon wing bolts and 5/8" x ¾" [16 x 19mm] wing bolt plates.

M3 x 8

M3 x 5

M3 x 5

Collar

❏

2. Carefully cut just into the covering around the wing bolt plates.

Do not cut into the wood.

Wheel pant

❏

3. Refer to the image to see which is the right and which is the left main landing gear (the gear sweeps aft). Using threadlocker on all the screws, mount the wheels to the axles with the wheel collars as shown, then fasten the wheel pants with M3 x 8 Phillips screws.

❏

4. Make sure the wheels are centered in the opening in the pants and roll smoothly. If necessary, remove the wheel pant and adjust the location of the wheel on the axle by moving the wheel collars, then retighten tightly.

❏

3. Remove the wing bolts and the wing bolt plates. Remove the covering from under where the wing bolt plate was.

❏

4. Glue the wing bolt plates to the wing using the wing bolts to hold them to the wing while the glue hardens.

❏

5. Mount the landing gear to the fuselage with six M3 x 12

Phillips screws and M3 washers and threadlocker.

24