SRM-3020T
Equipment
SAFETY
Use only approved attachments. Serious injury may result from the use of a non-approved attachment combination. ECHO
Incorporated will not be responsible for the failure of cutting devices, attachments or accessories which have not been tested and approved by ECHO Incorporated. Read and comply with all safety instructions.
◆
Do not attempt to modify this product. Serious injury can result from the use of any modified product.
◆
◆
◆
◆
Check unit for loose or missing nuts, bolts, and screws.
Tighten or replace as needed.
Inspect shield for damage and ensure that shield is properly installed, and that the cut-off knife is securely in place. Replace if either is damaged or missing.
Check that the cutting attachment is firmly attached and in safe operating condition.
Manufacturer recommended flexible non-metallic line is
◆
◆ installed in the trimmer head.
Assure that throttle trigger, throttle trigger lockout, and stop switch all work properly.
Check that handle and harness (if included) are installed and adjusted for safe, comfortable operation. See
Assembly section for proper adjustment.
Moving parts can amputate fingers or cause severe injuries.
Keep hands, clothing and loose objects away from all openings.
◆
ALWAYS stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop before
◆ assembling unit, removing obstructions, clearing debris, or servicing unit.
Do not connect spark plug lead to spark plug until unit is ready for use.
◆
◆
DO NOT start or operate unit unless all guards and protective covers are properly assembled to unit.
NEVER reach into any opening while the engine is running.
Moving parts may not be visible through openings.
X7502350103
© 05/22 ECHO Incorporated
13
SAFETY SRM-3020T
◆
◆
◆
Position wiring safely to prevent snagging, separation of connectors, or breakage during operation. Gather excess wire, and secure with wiring clamp if provided on equipment, or tuck behind the air filter area. Do not place wiring directly against hot engine components.
Check wiring and connectors for nicks, cuts, exposed wire, or other damage, and repair or replace as needed. Exposed wire or connectors can cause shocks, sparks, and risk of fire or explosion, resulting in serious injury.
Check wire terminals for secure connections.
Periodically Check fuel system (fuel lines, vent, grommet, fuel tank, and fuel cap) for leaks especially if the unit is dropped. If damage or leaks are found, do not use unit, otherwise serious personal injury or property damage may occur. Have unit repaired by an authorized servicing dealer before using.
14 X7502350103
© 05/22 ECHO Incorporated
