SRM-3020T
Operation with Blades
OPERATION
Metal blades are very sharp and can cause severe injuries, even if unit is off and blades are not moving. Avoid contact with blades. Wear gloves to protect hands.
Blade use demands specific brushcutter configuration.
Operation without specified shield, barrier bar or U-handle, and harness can result in serious personal injury. Follow installation instructions.
Pro Maxi-Cut
Grass / Weed
Blade
Support
Handle, with or without barrier bar
Shield with cutoff knife
Harness
Upper plate/flat washer
Hex nut
New cotter pin
Tri-Cut Grass /
Weed Blade
Metal Grass /
Weed Blade
U-handle or support handle with barrier bar
Harness
Hex nut
New cotter pin
Metal Brush /
Shield without cut-off knife
Clearing
Blades
U-handle*
Upper / Lower blade plates
*ANSI standards require brushcutters be equipped with a barrier bar or restrictive harness. U-handle ensures a higher safety factor.
Do Not install blades on GT (Curved Shaft) model trimmers.
• Use only ECHO approved parts. Failure to use the correct parts can cause the blade to fly off. Serious injury to the operator and/or bystanders can occur.
• Arbor diameter of upper blade plate must match arbor diameter of blades.
X7502350103
© 05/22 ECHO Incorporated
19
