ST Micro Connect 2 Introduction
●
●
●
●
●
●
The ST Micro Connect 2 can operate in conjunction with the following STMicroelectronics software products:
ST20 Embedded Toolset R2.3.1 and later
ST40 Micro Toolset R4.0.2 and later
ST200 Micro Toolset R6.1 and later
STxP70 Toolset R3.3.0 and later
STLinux 2.2 and later
STAPI SDK 0.7.0 and later
For details of the latest product availability please contact your ST FAE or ST support centre.
1.3 ST Micro Connect 2 power up
On power up or reboot the ST Micro Connect 2 goes through the following sequence.
The PWR LED illuminates when power is applied and the LEDs on the ST Micro Connect 2 front panel are illuminated in the following order: ACTIVE, CONNECT, ERROR. The LEDs then cycle for a few seconds to indicate that the ST Micro Connect 2 software is running. For a description of the status LEDs, see Appendix C: LEDs on page 43 .
On boot-up, the LCD displays a ready message and then cycles the Status and configuration display , see Chapter 2: LCD interface on page 13 .
Figure 3.
ST Micro Connect 2 front panel
®
ST MICRO CONNECT 2
POWER TARGET NEXT SELECT
ERROR
CONNECT
ACTIVE
Power button
Power
LED
VHDCI - LVDS connector LCD LCD
Next button
Select button
Status
LEDs
Please refer to Appendix F on page 49 for details of CE compliancy, warnings and safety critical information and end-of-life disposal instructions.
7912386 Rev 12 11/58
