ST Micro Connect 2 LCD interface
Note:
The ST Micro Connect 2 has a sixteen character by two line LCD that is used to display status information and to configure the ST Micro Connect 2.
The LCD has two modes of display:
● Status display , see Section 2.1
These pages display configuration and status information for the ST Micro Connect 2.
● Configuration menu , see Section 2.2
This menu can be used to configure various aspects of the ST Micro Connect 2 such as Ethernet IP address and Gateway IP address.
On boot-up, the LCD displays a ready message then the pages from the Status display are displayed in turn. Press the Select button from the Status display to access the
Configuration menu . The Next button can be used in both displays to navigate the various pages.
The LCD can also be used to display messages using the host utility, stmcconfig (see
Section 5.10 on page 26 ). Messages that are longer than 16 characters are scrolled.
The Status display pages are organized in a circular list. If no buttons are pressed, each page is displayed for 30 seconds after which the next page in the list is displayed.
The Status display pages are:
1.
Ethernet IP
2. Ethernet Mask
3. Default Gateway
4. USB IP
5. USB Mask
6. Connect Status
7. Version (software and hardware version numbers)
7912386 Rev 12 13/58
