Programming a development board EPLD
6.2
Note:
ST Micro Connect 2
epldprog command line
epldprog has the following command line syntax: epldprog [ options ] < stmc2 > < command > < filename >.jbc
where:
●
●
●
● options
<stmc2>
are listed in
is either the name of the ST Micro Connect 2 or its IP address
<command>
Table 5
options are listed in Table 6
<filename> .jbc
is the name of the JBC file containing the information for programming the EPLDs
If you have .pof
format files instead of .jbc
, these can be converted to JBC format using the Altera Quartus programmer software.
Table 5.
epldprog options
Option
--convertor
--help
--parameters
--tck_frequency
Description
The convertor type is automatically detected, but may be specified explicitly with this option; supported values are:
STMC_Type_A This specifies that a Type A STMC I/O convertor is being used to interface to the target board.
STMC_Type_G This specifies that the ST Micro Connect 2 is connected directly to a Type G format LVDS convertor on the target board.
STMC_Type_K This specifies that the ST Micro Connect 2 is connected directly to a Type K format LVDS convertor on the target board.
Convertors are described in detail in Appendix B: Target interface on page 40 .
Displays help for epldprog.
TargetString parameters, see the ST TargetPack User manual (8020851).
Frequency in Hertz. The default is 1000000 Hertz.
The JBC file provides command line options for use with epldprog . Possible commands are shown in Table 6 .
Table 6.
JBC command line options
Command
INFO
PROGRAM
VERIFY
Description
Displays the information on the EPLD.
Programs and verifies the EPLD.
Checks that the programming information contained within the EPLD and the JBC file have no conflicts.
Refer to your STMicroelectronics board datasheet for further information about programming EPLDs.
34/58 7912386 Rev 12
