Chapter 2: Basic Operation
Attaching Carrying Accessories
• Using a coin, or other conductive item, connect pins 5 and 6 of the Omnii battery contacts for at least 6 seconds.
Pin 6 Pin 5
• Replace the battery and power Omnii on. The terminal will boot as if from a cold reset.
2.5
Attaching Carrying Accessories
Psion Teklogix recommends that a carrying accessory—a hand strap or shoulder strap—be
installed on Omnii before use. For detailed information, please see “Carrying and Protective
Accessories” on page 173.
2.6
Calibrating the Touchscreen
Note: The touchscreen function can be turned off (see “Touch” on page 122).
The Omnii touchscreen feature is factory-calibrated and ready-to-go; however, over time the touchscreen's operating parameters may change, and it may need to be recalibrated for
correct operation. Refer to “Calibrating the Touchscreen” on page 44 for details.
2.7
Configuring Your Wireless Network
Omnii contains an integrated 802.11b/g radio module. The
Wi-Fi Config
application is used to configure the radio for one or more wireless network profiles. To configure the radio,
follow the steps outlined under the following heading “Wireless Networking”.
To configure your
Bluetooth
settings, please go to “Bluetooth® Setup” on page 125.
To see the radio specifications, please go to “Wireless Radios” on page 199.
18
Psion Teklogix Omnii XT10 Hand-Held Computer User Manual
