Chapter 3: Getting To Know Your Omnii
The Display
3.3
The Display
Omnii is equipped with display backlighting to improve character visibility in low light conditions. The backlight switches on when a key is pressed.
3.3.1
Adjusting the Display Backlight
The behaviour of the display backlight and the intensity of the backlight can be specified in the
Display Properties
dialog box in the
Control Panel
.
Note: Refer to
“Backlight” on page 90
for details about the Display Properties dialog box.
3.3.2
Calibrating the Touchscreen
If your Omnii touchscreen has never been calibrated, or if you find that the stylus pointer is not accurate when you tap on an item, use the
Stylus Properties
dialog box in the
Control
Panel
to recalibrate the screen.
• In the
Control Panel
, choose the
Stylus
icon to display the
Stylus Properties
window.
• Select the
Calibration
tab, and then choose the
Recalibrate
button.
44
• Follow the directions on the calibration screen to calibrate the screen.
Psion Teklogix Omnii XT10 Hand-Held Computer User Manual
Chapter 3: Getting To Know Your Omnii
Indicators
3.4
Indicators
Omnii uses LEDs (Light Emitting Diodes), onscreen messages, vibrations, and audio tones as indicators.
3.4.1
LEDs
Omnii is equipped with four coloured LEDs. This section outlines what these LEDs indicate.
Important: If an LED is illuminated in red, the operator should be cautious as this generally indicates an abnormal operating condition or active laser emission.
Figure 3.3 LED Status Indicators
1
2
3
4
1. Battery Charge Status
2. Operating System Status
3. GPS Status
4. Scanner Status
3.4.1.1 Battery Charge Status LED
The far left LED is reserved for battery charge status. This indicator is active even when the hand-held is inserted in a docking station (and in suspend mode) so that the charge status of the battery can be detected easily.
Psion Teklogix Omnii XT10 Hand-Held Computer User Manual
45
