advertisement
XA4200, XA4300
2CH/3CH/4CH
The XA4200/XA4300 can be configured for three different input modes: 4 channel, 3 channel or
2 channel.
4 Channel
2CH
3CH
4CH
When the input selector is set to
4 CH, the amplifier will operate as a standard 4 channel amp with all
RCA inputs connected.
2 Channel
2CH
3CH
4CH
When the input selector is set to
2 CH, the amplifier is configured for bridged stereo operation. The amplifier will need a two channel input even though there are four inputs. In the 2 CH the following inputs will be used:
®
REAR
HI-LEVEL
INPUT OUTPUT
RR
INPUT OUTPUT
LF FRONT
HI-LEVEL
REAR
HI-LEVEL
INPUT OUTPUT
LR
RR
INPUT OUTPUT
LF
RF
FRONT
HI-LEVEL
3 Channel
2CH
3CH
4CH
When the input selector is set to
3 CH, the amplifier is configured for stereo/mono operation. The front channels of the amplifier operate in stereo mode. The rear channels of the amplifier are internally bridged for mono operation. In 3 CH the following RCA inputs will be used:
Note
Although the above illustrations indicate the low level input being used, the same connections would apply to the high level input.
REAR
HI-LEVEL
INPUT OUTPUT INPUT OUTPUT
FRONT
HI-LEVEL
REAR
HI-LEVEL
INPUT OUTPUT
RR
INPUT OUTPUT
LF
RF
FRONT
HI-LEVEL
High Inputs
5910 XA4CH_E.p65
11 01/23/01, 12:24 PM
11
advertisement
Related manuals
advertisement
Table of contents
- 3 Features
- 3 Installation
- 3 Disconnect Battery
- 3 Supplies and Tools Needed
- 4 Location and Mounting
- 4 Routing Wires
- 5 Wiring
- 5 Power
- 5 Power Terminal (+12V)
- 5 Ground Terminal (GND)
- 5 Remote Terminal (REM)
- 5 Fuses
- 6 Remote Level Control
- 6 Input Wiring
- 7 Remote Level Control (XA4300)
- 7 Connecting Other Amps
- 10 Indicators and Controls
- 10 Crossover (X-OVER)
- 10 Power/Protect Light
- 11 2CH / 3CH / 4CH
- 12 Level
- 12 Testing
- 12 Reconnect Battery
- 12 Test Power Wiring
- 12 Test Speaker Connections
- 13 Troubleshooting
- 14 Specifications
- 15 Warranty