PREPARATION FOR USE. Sylvania 6509DD

TD001.QX33 03.1.31 10:31 PM Page 10

Satellite Box or

Cable Box

OUT

(Not supplied)

IN

PREPARATION FOR USE

ANTENNA/CABLE CONNECTIONS

From Cable System or

Satellite Dish

VHF/UHF Antenna

(Not supplied)

VHF Antenna

(Not supplied)

From

Cable System

DC 13.2V

UHF Antenna

(Not supplied)

ANT.

L

AUDIO OUT

R

COAXIAL or

VHF/UHF

Combiner

(Not supplied)

ANT.

75-ohm Coaxial

Cable (Not supplied) or

Flat twin-lead cable

[Fig. 4]

or

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical.

NOTE:

Before plugging the an antenna into the ANT. IN jack of the TV/DVD, check that the pin is not bent. If it is bent, straighten the pin as illustrated, then plug the pin into the ANT. IN jack of the TV/DVD.

VHF/UHF COMBINED ANTENNA

A VHF UHF 75 ohm combination antenna can be connected to ANT terminal.

VHF/UHF SEPARATE ANTENNAS

In some areas it will be necessary to use an outdoor antenna.

CABLE WITHOUT CONVERTER/

DESCRAMBLER BOX

Use this connection if your cable system connects directly to your TV/DVD without a converter box.

Use the TV/ DVD Remote Control to select channels.

Bent pin

Cable

Plug

(Needs to be straightened)(Straight pin)

CABLE WITH CONVERTER/DESCRAM-

BLER BOX OR SATELLITE BOX

If your cable service supplies you with a converter box or if you use a satellite system, you can use the basic connection shown here.

Channel selection must be made with the converter box or satellite box. This means that channels cannot be changed using the TV/ DVD Remote Control.

TO VIEW A SCRAMBLED/UNSCRAMBLED

CHANNEL

1. Set the TV/DVD channel selector to the output channel of the Cable Converter Box or Satellite

Box. (Ex. CH3)

2.Select the channel to view at your Cable Converter

Box or Satellite Box.

INDOOR ANTENNA

The Indoor Antenna (supplied) is detachable. Insert the stem of the antenna into the hole on the upper-back portion of the TV/DVD. Connect the Indoor Antenna to the

TV/DVD as shown in the diagram. For the best reception, fully extend the Indoor

Antenna and make the necessary adjustments. (Avoid touching the top section when adjusting.)

NOTE:

The connection of an Indoor antenna may not always give acceptable TV reception.

Indoor Antenna

(Supplied)

Flat twin-lead cable

Matching

Adapter

(Supplied)

DC 13.2V

AUDIO OUT

COAXIAL

ANT.

ANT.

[Fig. 5]

EN

0C28

TD001.QX33 03.1.31 10:31 PM Page 11

CONNECTING TO EXTERNAL INPUT JACKS

When you watch a program recorded on an another source (VCR or video camera), use the audio/video input jacks on the front of the TV/DVD.

Connect the audio/video output jacks of another source to the

AUDIO L/R and VIDEO jacks of this TV/DVD. Then press SELECT until "AUX" appears on the screen.

AUX

NOTE:

•

When you connect a monaural VCR (another source) to this TV/DVD, connect the Audio output jack of the monaural VCR (another source) to the

AUDIO L jack of this TV/DVD. The audio will output in both L and R channel equally.

[Another source] To the audio output jacks

To the video output jack

etc.

MOBILE CONNECTION

Audio/Video cables

(not supplied)

[Front of the TV/DVD]

VIDEO

VIDEO L AUDIO R POWER

L AUDIO R

[Fig. 6]

WARNING: The driver should never watch the TV/DVD while operating a motor vehicle.

CAUTION:

•

When used in moving vehicle, be sure that the unit is secure at all the times to prevent injury.

Consult a professional installer.

•

If you use the TV/DVD with the vehicle’s engine off, recharge the vehicle’s battery after about every 4 hours of use to prevent it from running down. After you finish using the TV/DVD be sure you unplug the car-battery cord from the cigarette-lighter socket.

•

Do not use this TV/DVD while driving.

•

Do not leave this TV/DVD in a car.

•

This TV/DVD is not designed for use in a car.

1) The supplied indoor antenna is adequate when your vehicle is stationary. For best reception on the road, use a high-quality VHF/UHF mobile TV antenna.

2) Attach the car battery cord to the DC13.2V(12V) connector on the back of the TV/DVD. Then, connect the other end to your vehicle’s cigarettelighter socket.

To the vehicle's cigarette-lighter socket

VHF/UHF Combination

Mobile Antenna

(Not supplied)

NOTES:

•

Be sure your vehicle has a 13.2-volt (12-volt), negative-ground electrical system.

•

Be sure you use only the supplied car battery cord.

Using another cord could damage the TV/DVD.

•

Be sure the socket is free of ashes and other debris.

•

Be sure to push the car battery cord’s plug completely into the cigarette-lighter socket.

•

Always unplug the car battery from the cigarettelighter socket before you unplug it from the

TV/DVD.

•

You must disconnect the car battery cord from the

TV/DVD before you can use the AC power.

•

Be sure to replace the fuse with only the same type,

6A, 250V.

Car battery cord

(Supplied)

ANT.

DC 13.2V

AUDIO OUT

R

COAXIAL

ANT.

DC13.2V

EN

0C28