Network Settings (LAN). D-Link DVG-7022S, DVG-6004S, DVG-7044S, DVG-7062S

21

Network Settings (LAN)

LAN interface mode※

Router: The system serves as a router with NAT.

Bridge: The system serves as a bridge between WAN port and LAN port without NAT. (LAN default gateway will still be accessible for configuration).

LAN IP/Subnet mask

Gateway LAN Port IP address and the subnet mask value. Please note that Gateway is built with NAT:

Gateway LAN Port IP address cannot be in the same section as the NAT LAN Port IP address, or else it is unable to make or receive calls. For example, if the NAT LAN Port IP address is 192.168.8.1, then

Gateway LAN Port cannot be ranged between 192.168.8.1 ~ 192.168.8.254. If so, please change the LAN

port IP address, (e.g. setting the IP address to 192.168.99.254.)

DHCP Settings

Enable DHCP Server: Enable or Disable DHCP server service of gateway.

IP Pool Starting Address: The first IP address to be assigned to DHCP clients.

IP Pool ending Address: The last IP address to be assigned to DHCP clients.

Lease Time: The valid period of an assigned IP address.

Domain Name Server Assignment: The DNS information to be assigned to DHCP clients.

Auto : Assigns the same DNS information of WAN port to the DHCP clients.

Manual : Manually assigns the DNS information for DHCP clients.

Port of Web Access from WAN: Http port for WAN. To make this setting, the LAN Port must be used. WAN Port cannot make this setting. Always use port 80 when connecting to

LAN port. 0 is to disable http port for WAN.

Enable Web UI: It disables any access from WAN and LAN if ticked.

Enable Telnet Service: It allows user to make settings from Telnet.