Language. D-Link DVG-7022S, DVG-6004S, DVG-7044S, DVG-7062S

Language

The system provides English, Traditional Chinese, and Simplified Chinese to display text on Web pages.

Meanwhile, it will change the language for IVR (Interactive Voice Response).

Transit Call Control

If you wish to restrict a general user (one who is not required to enter the PIN code) to local calls only and prohibit him/her from making long-distance calls started with a prefix “0”, do the following steps:

1. Enable the Outbound Call Control function,

2. Set the PIN code for Outbound Level 5 to blank,

3. Set the Long-Distance Control Table to correspond with the Outbound Level 5 to prohibit making any call with the prefix “0” (as shown above).

Note: Transit Call Control is effective when it cooperate with Long-Distance Control Table.

Inbound Call Control: To determine when users make a phone call from a PSTN to

Gateway FXO whether or not they check the inbound PIN code while using a VoIP －only effective for incoming calls calling from a PSTN trunk.

Outbound Call Control: To determine when users utilize Gateway FXO interface to divert to a PSTN whether or not they check the outbound PIN code － only effective for outgoing calls being diverted to a PSTN Trunk.

PIN Code: Enter the PIN code (4-6 digits or leave blank. A blank indicates no PIN code is required at this level. Generally, the PIN at level 5 can remain blank to simplify the phone number.)

Enable: Enables the PIN code at each level.

Privileges: The level is divided into 0~5 (The levels are in descending order; 0 stands for the highest authority and 5 stands for the lowest.)