REFRIGERATOR SERVICE MANUAL

3-8 MULTI DUCT

1. Remove the upper and lower Caps by using a flat screwdriver, and remove

2 screws. (Figure 17)

2. Disconnect the lead wire on the bottom position.

2) Remove display frame assembly by making a gap between a display frame assembly and door with a flat blade screwdriver and pulling it forward. The cover dispenser is attached with a hook.

3-9 MAIN PWB

1) Loosen the 3 screws on the PWB cover.

Figure 17

w CAUTION: When replacing the dispenser cover in the reverse order of removal, be careful that the lead wire does not come out and the water tube is not pinched by the dispenser cover, as shown in the picture below.

2) Remove the PWB cover

3-11 DISPLAY PWB REPLACEMENT

1) Pull up and out on the dispenser cover to remove.

3) Disconnect wire harness and replace the main PWB in the reverse order of removal.

2) Follow the steps in the pictures

3-10 DISPENSER

1) Disconnect funnel and button assembly by pulling down and forward.

- 9 -

3-12 FUNNEL REPLACEMENT

1) Pull up and out on the dispenser cover to remove.

2) Disconnect the wire harness.

3) Replace in reverse order.