digital conductivity meter service manual

DIGITAL CONDUCTIVITY METER SERVICE MANUAL

8.3 Depress Calibrate switch (C) with probe OUT of fuel sample. After 3 seconds reading should be 10 times the probe calibration number +/- 005

(Figure 5).

Example: Probe No. = 40

Meter Reading = 400 +/- 5 or 395 to 405

8.4 Insert probe in fuel to upper holes and depress measure switch. Report reading after 3 seconds for stabilization. Due to the polarization of the fuel sample the apparent reading will continue to change. Only the reading 3 seconds after depressing the measure switch is correct.

9.0 PARTS LIST

Batteries (3 required) 152-90-5341

Display PC Board 152-03-0000

Pre-Amp PC Board 152-04-0000

A-D Converter PC Board 152-05-0000

Probe 152-09-0000

The information contained in the accompanying document is proprietary and confidential, and may not be copied in any manner whatsoever without prior written consent of Emcee Electronics,

Inc. The document and the material therein may not be used for any purpose other than that intended by Emcee Electronics, Inc.

COPYRIGHT 2002 EMCEE ELECTRONICS, INC.

REVISION DATE: FEBRUARY 23, 1996

PAGE 8 OF 14