9010/Telnet Host Configuration. Zebra Software
Reklama
Reklama
CHAPTER 6 9010/TELNET HOST
CONFIGURATION
9010/TELNET HOST CONFIGURATION
6
9010/Telnet Host Configuration 6 - 3
General Host Options
Field
Name
Enabled
Emulation and protocol
Terminal range
Auto terminal number assignment (not supported by Direct
TCP)
Description
The unique name of the host.
Default: Unnamed Host
When selected the host task is started when the TekTerm Server starts.
Emulation and protocol combination for this host.
Select: 9010/Telnet
Terminal number range that communicates with this host.
Range: 1 to 3840. For S900L range is 1 to 50.
Default: 1 to 32
For information on selecting the terminal range see Chapter 19: “Setting Terminal
Numbers on the General Host Options Screen”
When selected, TekTerm Server assigns terminal numbers to all mobile devices that use this session.
When not selected, terminal numbers must be assigned on the mobile devices.
Default: Selected.
9010 Emulation Options
Field
Refrain from sending
On-line & Off-line messages
Description
Narrow band and 802.IQ v1 only. When selected the TekTerm Server does not forward terminal-offline and terminal-online messages from the base station to the host.
Default: Not selected.
6 - 4 TekTerm Server Software User Manual
9010 Protocol Options Screen
9010/Telnet Options
Field
Monitor Polls
Description
When selected, the TekTerm Server monitors messages and polls from this connection.
Hosts usually send messages or null polls to the TekTerm Server with a period of approximately 40 seconds.
If the TekTerm Server does not receive a message or poll within 40 seconds, it closes the connection.
Default: Not selected.
Note:
For older Unix handlers (hosts), this parameter should be deselected. In all other cases, this parameter should be selected.
Pobierz
Reklama