15.1.9 Adjusting Menu Transparency. Lorex LH1608, LH1624, LH160 ECO6 SERIES, LH1612, LH1616

15 Using the Main Menu

2. Press and hold the Stop ( ) button on the front panel until the DVR restarts. The resolution will be reset to 1024 x 768 and the DVR will restart. When the DVR restarts, click Yes to confirm the default resolution.

Note

If your system resolution is already in 1024 x 768, pressing and holding the Stop button will not restart the system.

15.1.9

Adjusting Menu Transparency

You can increase or decrease the transparency of the on-screen menus.

To adjust the transparency of on-screen menus:

1. Click the Output tab.

2. Drag the Transparency slider to adjust transparency.

3. Click Apply to save your settings.

15.1.10

Adjusting the Video Margin

If you connect your DVR to a BNC monitor, you can adjust the video margins.

Note

You must select the BNC output mode to adjust the margins. Press 0 three times on the remote control to switch the output mode between BNC mode and VGA/HDMI mode. When BNC mode is selected, the mouse cursor appears on the BNC monitor.

To adjust the video margin:

1. Click the Output tab.

2. Click the Margin button.

3. Drag the sliders to the left or right to adjust the Left, Right, Top, or Bottom Margin.

4. Click Apply to save your settings and click OK to confirm.

15.1.11

Adding Privacy Zones

A privacy zone allows you to block out up to 4 portions of each channel with a black square.

CAUTION

Areas covered by privacy zones are not visible in recordings.

To configure a privacy zone:

1. Click the Privacy Zone tab.

#LX400007; r. 1.0/12121/12123; en-US

44