Configuring Hard Drive Recording Mode. Lorex LH1608, LH1624, LH160 ECO6 SERIES, LH1612, LH1616

17 Using the PC/Mac Client Software

2. Configure the following:

• Alarm In: Select the channel that you wish to configure.

• Alarm Type: Select the alarm type N/O (normally open), N/C (normally closed), or select OFF.

• Buzzer: Select the "beep" duration when an event occurs.

• Latch Time: Select the desired latch time when an alarm triggers.

• Show Message: Select the checkbox so that the system displays a warning message during an alarm recording.

• Send email: Select the checkbox for the system to send out email alerts during alarm recording.

• Full Screen: Select the checkbox to enable the system to go into Full-screen View when an alarm triggers.

• Alarm Out: Select the checkbox to enable alarm out devices to activate.

• Enable Record: Select the checkbox to enable system recording when an alarm triggers.

• Post Recording: Select the desired post recording time after an alarm triggers.

• Record Channel: Select the channels that the system should record during an alarm trigger.

3. Click Save to apply your settings.

17.22

Configuring Hard Drive Recording Mode

1. Click the Remote Setting tab, and click Device>HDD.

2. In the Overwrite drop-down menu, select Auto to enable overwrite mode.

Note

When overwrite is enabled, the system deletes the oldest footage (first in, first out) when the hard drive is full. You can also select a desired amount of days or hours the system should retain data. For example, if you select 30 days, the hard drive will begin to overwrite itself after 30 days. Note that your hard drive must be large enough to store video for the selected duration.

3. Click Save to apply your settings.

17.23

Configuring PTZ Parameters

The system is capable of controlling PTZ cameras (not included) that are connected to the system. Parameters for setting up PTZ cameras can be set either on the DVR locally or via the remote client.

#LX400007; r. 1.0/12121/12123; en-US

90