KIP Touchscreen
Length
Two methods determine the length of the copy in the KIP printer. These two methods are Auto (may also be known as Synchro Cut or Automatic Cut) and Standard Cut.
Auto
This mode allows the media length to be determined by the original length. This also takes into consideration any enlargements or reductions that are applied to an image as well, to prevent excess media without image.
NOTE
Auto Length works in conjunction with Auto Roll noted in 2.6.1.
Standard
This mode allows the media length to be determined by a standard length or a length set manually by the user with a number pad. a. Select Standard Cut. A sub screen will appear. When Standard is used, the roll must also be selected.
If Auto Roll is selected in the Media region the following screen will appear, prompting the media to be selected. Select the roll.
No part of this publication may be copied, reproduced or distributed in any form without express written permission from KIP. 2014 KIP.
- 39 -
KIP Touchscreen
If a roll is already selected in Media, then the following screen appears now only requesting the length. b. Once the roll is determined (if so required) the length can now be set.
•
Standard Length
•
Auto Length
• Custom Length c. Standard Length – use an industry standard length. Select the length and press Enter. d. Auto Length – uses the length of the original to determine the copy length. Select and press Enter.
No part of this publication may be copied, reproduced or distributed in any form without express written permission from KIP. 2014 KIP.
- 40 -
