- No category
advertisement
LED Feedback
The following table provides a description of the PCS250G
Communicator Module LEDs.
LED
SIM
Card 1
SIM
Card 2
GPRS
GSM
Signal
Strength
Feedback
Solid green = SIM card 1 is installed on the GPRS
Module
Quick green flashing = SIM card 1 is exchanging data
Slow green flashing = Searching the network
Flash red (once) = SIM card 1 is defective
Off = SIM card 1 is not installed, not active, or currently not in use
Solid green = SIM card 2 is installed on the GPRS
Module
Quick green flashing = SIM card 2 is exchanging data
Slow green flashing = Searching the network
Flash red (once) = SIM card 2 is defective
Off = SIM card 2 is not installed, not active, or currently not in use
Solid green = unit is set for GPRS operation
Quick green flashing = exchanging data
Option not available on the PCS250G.
LED 1, 2, and 3 (bottom three LEDs) indicate the strength of the incoming antenna signal.
Communication Loss
Upon loss of communication with the panel, the PCS250G LEDs will behave in the following manner:
1) GPRS LED displays is off; the SIM card and signal strength
LEDs display their status for about 3 seconds.
2) Signal strength LED remains OFF; GPRS (green) is turned
ON, followed in turn by SIM2 (orange) and SIM1 (red). When a LED is ON, all others are off. Each LED lights for about 200 ms. This sequence is repeated two times.
3) This cycle repeats until communication is restored.
Overview Page 7
advertisement
Related manuals
advertisement
Table of contents
- 4 Features
- 5 In the Box
- 5 Required/Optional Items
- 5 Compatibility
- 6 System Components
- 7 LED Feedback
- 7 Communication Loss
- 8 SIM Card Functionality
- 8 Tamper Switch Functionality
- 9 Specifications
- 10 SIM Card Connection
- 11 GPRS Connections
- 12 Communication Bridge
- 13 UC300 Connection
- 14 Optional Power Supply Connections
- 14 Using an External Power Input
- 15 Antenna Extension Installation (Optional)
- 15 Module Installation
- 17 Frequency Band
- 17 Bandwidth Saver Mode
- 17 SMS Forwarding
- 17 Communicating Using Text Messages
- 18 Programming Phone Numbers At The Panel
- 18 Forwarding SMS Text Messages
- 18 Receiving Text Messages
- 18 Configuring GSM Network Provider Information
- 20 Configuring BabyWare Access
- 20 Programming and Registering GPRS Reporting Options
- 22 SMS Backup Reporting
- 22 Configuring the PCS250G for SMS Backup Reporting
- 24 Troubles
- 24 Text Message Notification
- 25 SMS Language
- 26 Arm/Disarm System via Text Message
- 27 List of SMS Commands
- 29 Public Network
- 30 Private Network
- 32 End User SMS Programming
- 32 End User SMS Programming with Digiplex EVO
- 32 End User SMS Programming with MG/SP / E-Series
- 33 View GPRS IP Information
- 34 Viewing GPRS IP Information with Digiplex EVO
- 34 Viewing GPRS IP Information with MG/SP / E-Series
- 35 Alarm Messages
- 36 Arming/Disarming Messages
- 37 Trouble Event Messages
- 38 Trouble Restore Messages
- 38 UC300 Messages
- 39 UC300 Alarm Messages
- 40 UC300 Arming/Disarming Messages
- 40 UC300 Trouble Messages
- 43 UC300 Trouble Restore Messages