advertisement
4 INSTALLING AND CONNECTING THE PVR
4.1
4.1.1
L
OOP THROUGH CONNECTION
: ( IMPORTANT )
Connect the Loop through F-F connector on LNB1 out to LNB 2 in –see the below picture
W
ITHOUT THIS LOOPED CONNECTION THE
PVR
WILL
NOT FUNCTION
.
F
OR ASSISTANCE EMAIL
-
SUPPORT
@
UEC
.
COM
.
AU
11 | P a g e
©
Copyright 2012 Altech UEC (Pty) Ltd
N
OW CONNECT TO
TV
SET VIA THE FOLLOWING
CONNECTION OPTIONS
:
4.2.1
4.2.2
4.2
O
PTION
A: AV C
ONNECTORS
(S
TANDARD
D
EFINITION
TV)
Connect the satellite signal to the LNB IN input (#2) on the decoder
Connect the Audio / Video cables to the audio (#9) and video (#11) outputs on the decoder and then to the audio and video inputs on the TV or home theatre system.
4.3
4.3.1
4.3.2
O
PTION
B: HDMI C
ONNECTOR
(H
IGH
D
EFINITION
TV)
Connect the satellite feed to the LNB input (#2) on the decoder
Connect a High Definition cable to the HDMI connector (#8), and then connect the other end of the cable to the HDMI connector on the TV.
4.4
4.4.1
4.4.2
4.4.3
O
PTION
C: HDMI C
ONNECTOR
(AV H
OME
T
HEATRE
SYSTEM AND A
H
IGH
D
EFINITION
TV)
Connect the satellite feed to the LNB IN input (#2) on the decoder
Connect a High Definition cable to the HDMI connector (#8), and then connect the other end of the cable to the HDMI input connector of the AV home theatre system.
Then connect the output HDMI of the AV home theatre system to the TV.
NOTE:
C
ONNECTING YOUR TELEVISION DIRECTLY TO THE AUDIO
/
VIDEO OUTPUT OF YOUR
S
ET
T
OP
B
OX
WILL ASSURE A MORE VIVID PICTURE AND ENHANCE YOUR VIEWING ENJOYMENT
.
12 | P a g e
©
Copyright 2012 Altech UEC (Pty) Ltd
advertisement