advertisement
4.5.1
4.5.2
4.5.3
4.5.4
4.5.5
4.5.5
4.5.6
4.5
Q
UICK
START GUIDE FOR EXISTING
A
URORA
/ DSD4121
OR OTHER
VAST I
NSTALLATION
Remove decoder from packaging.
Insert supplied batteries into the remote control.
Ensure you have connected the loop cable as per 4.1.1
Connect to existing TV and satellite dish to the back of the PVR.
Power up the PVR and wait while the PVR starts up.
If the PVR does not scan first time, Press help & follow installation prompts to change LNB settings.
PVR should lock to service and display video.
5 S
MART
C
ARD
The smart card is paired to this PVR which means that this smart card cannot be used in any other PVR. The smart card is owned & controlled by the network operator. Activation of a smart card is subject to conditions set out by the operator.
6 R
ESTORING TO FACTORY DEFAULTS
Resetting to factory defaults can be useful if you have changed some settings and lost some functions. Resetting will restore the decoder back to its original configuration and all personalised settings will be reversed. The only setting that is not reset is the LNB setting.
Please manually edit this setting to the desired value. Refer to Page 25
6.1
6.1.1
P
IN
N
UMBER
The default pin number is 1234.
13 | P a g e
©
Copyright 2012 Altech UEC (Pty) Ltd
advertisement