Press AIR DIRECTION button to lock louver in desired position.
The AIR DIRECTION and SWING buttons will be disabled when the air conditioner is not in operation (including when the
TIMER ON is set).
Do not operate the air conditioner for long periods with the air flow direction set downward in cooling or dry mode.
Otherwise, condensation may occur on the surface of the horizontal louver causing moisture to drop on to the floor or on furnishings.
Do not move the horizontal louver manually. Always use the AIR
DIRECTION or SWING button. If you move this louver manually, it may malfunction during operation. If the louver malfunctions, stop the airconditioner once and restart it.
When the air conditioner is started immediately after it was stopped, the horizontal louver might not move for approximately 10 seconds.
Open angle of the horizontal louver should not be set too small, as
COOLING or HEATING performance may be impaired due to too restricted air flow area.
Do not operate unit with horizontal louver in closed position.
When the air conditioner is connected to power (initial power), the horizontal louver may generate a sound for 10 seconds, this is a normal operation.
43
How to use the indoor unit
Manual operation (without remote control)
Manual operation can be used temporarily in case you can not find the remote controller or its batteries are exhausted.
1. Open and lift the front panel up to an angle until it remains fixed with a clicking sound.
2. One press of the manual control button will lead to the forced AUTO operation.
3. Close the panel firmly to its original position.
Manual control button
Auto/Cold
Attention
Once you push the manual button, the operation mode is shifted in an order as: AUTO, COLD, OFF.
Push the button twice, the unit will operate in forced COLD mode. This is used for testing purposes only.
Third press will stop the operation and turn off the air conditioner operation.
To restore the remote controller operation, use the remote controller directly.
Manual operation
44