Grounding Instructions. Clarke S12cc
Add to my manuals
23 Pages
Clarke S12cc is an upright vacuum cleaner designed for commercial and industrial use. It features a powerful motor for deep cleaning carpets and hard floors, a large capacity dust bag for extended cleaning sessions, and a lightweight design for easy maneuverability. The S12cc also includes a variety of attachments for cleaning different surfaces, including a crevice tool for reaching tight spaces and an upholstery brush for cleaning furniture.
advertisement
GROUNDING INSTRUCTIONS
Preparation:
The following are instructions for connection to the power supply and the electrical ground.
This machine must be connected to the electrical ground to protect the operator from electrical shock. The machine has an approved power cord with three conductors and a plug with three terminals. Connect the plug to a receptacle that has three holes and is connected to the electrical ground.
The green (or green and yellow) conductor in the cord is the ground wire. Never connect this wire to any terminal other than the ground pin terminal.
DANGER:
Improper connection of the equipment-grounding conductor can result in risk of electric shock. Check with a qualified electrician or service person if you are in doubt as to whether the outlet is properly grounded.
Do not modify the plug provided with the appliance. If it will not fit the outlet, have a proper outlet installed by a qualified electrician.
This machine is for use on a 110 to 120 Volt AC 60 cycle electric circuit. Make sure you have the correct frequency and voltage before connecting the power cord to an outlet.
The machine has a plug as shown in figure A. If a receptacle connected to the electrical ground as shown in figure A is not available, use an adapter as shown in figure C. This adapter must be connected as shown in figure B to an electrical ground in the electrical outlet. Make sure you use the plate screw and the tab to fasten the adapter.
WARNING: Always use this machine with an AC three-conductor electrical system connected to the electrical ground. Replace any worn, cut or damaged cords. Replace any damaged plugs, receptacles or connector bodies.
WARNING: Do not cut, remove, or break the ground terminal. Do not try to fit a three-terminal plug into a receptacle or connector body that does not fit the plug, see your Authorized
Clarke Dealer to get an authorized person to make the connection.
WARNING: Do not move the machine over an electrical cord. Always lift the cord over the machine.
EXTENSION CORDS:
Use only an approved extension cord with three conductors, a plug with three terminals and a connector body with three holes. This machine has a power cord with wire size 18
AWG (AWG means American Wire Gauge).
WARNING: If you use an extension cord, use an extension cord with minimum wire size 16 AWG.
Do not use an extension cord longer than 50 feet. Do not join two extension cords.
Clarke
®
Upright Vacuum Operator's Manual
Grounding Blade is longest of the three blades
FIGURE A
Adapter
Grounded
Outlet Box
Grounded
Outlet Box
Metal
Screw
Grounding
Tab
FIGURE C
FIGURE B
Page -5-
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 4 Operator Safety Instructions
- 6 Grounding Instructions
- 7 Consignes de sécurité de l'utilisateur
- 9 Instructions visant la mise a la terra
- 10 How to Prepare the Machine For Operation
- 10 How to Operate the Machine
- 11 Maintenance
- 11 The Belt to Drive the Brush
- 11 How to Replace the Belt
- 12 What to do About the Wear of the Brush
- 13 Steel Core Brush
- 13 Lubrication
- 13 Electrical Maintenance
- 14 Trouble Shooting Guide
- 15 Wiring Diagram
- 16 Collector Cup Assembly Drawing
- 17 Collector Cup Assembly Parts List
- 18 Base Assembly Drawing
- 19 Base Assembly Part List
- 20 Handle and Filter Bag Assembly Drawing
- 21 Handle and Filter Bag Assembly Parts List