Placing the Dishwasher. Bosch Dishwasher

14"

(355mm)

21"

(533mm)

Figure 18

Placing the Dishwasher/ Securing the Dishwasher

PLACING THE DISHWASHER

1) Straighten and position the hot water supply line and the electrical supply cable as shown in Figure 18 so that they will align with their channels under the dishwasher base.

2) Position the dishwasher close enough to the enclosure so that you can run the dishwasher drain hose to the under sink drain connection. Make certain that the hot water supply line and the electrical supply cable are in their channels under the dishwasher base, as shown in Figure

19, letter A.

3) Place the dishwasher directly in front of the enclosure.

4) Perform a level check as shown in Figure 19. Adjust the rear leveler by turning the center screw at the front of the dishwasher, as shown in Figure 20, letter B. Turning the screw clockwise raises the rear of the dishwasher. Adjust the front levelers by turning them with a screwdriver, as shown in Figure 20, letter C. Turning the levelers to the right raises the dishwasher. If additional height is needed, shims may be added under the leveler feet.

5) Push the dishwasher into the enclosure.

A

SECURING THE DISHWASHER

Drive the mounting screws through the holes in the mounting brackets, as shown in Figure 21, letter A for Top

Mount, or as shown in Figure 21, letter B for Side mount.

Figure 19

10

C

B

Figure 20

A

B

Figure 21