WV-NW484S_manual_eng

(1)

(2)

(3)

(4)

(5)

(6)

Configure the Servers Settings [Server setup]

The mail server and FTP server settings can be configured on the "Server setup" page.

The "Server setup" page has 2 tabs: the [Mail] tab and the [FTP] tab.

Setting the mail server [Mail]

Click the [Mail] tab on the "Server setup" page.

On this page, the settings for the mail server used that sends the alarm mail can be configured.

No.

(1)

(2)

Item

[SMTP server address]

[POP server address]

Description

Enter the IP address or host name of the SMTP server used to send emails. To enter the host name for "SMTP server address", it is necessary to configure the DNS settings on the [Network] tab of the "Network setup"

page. (

→ page 52)

Number of characters for the server address: 1 to 128

When "POP before SMTP" is selected for "Authentication", enter the IP address or host name of the POP server. To enter the host name for

"POP server address", it is necessary to configure the DNS settings on

the [Network] tab of the "Network setup" page. (

→ page 52)

Number of characters for the server address: 1 to 128

Select the authentication method to send e-mails from the following: (3) [Authentication]

Default: None

• When you do not know the authentication method for sending emails, consult with the network administrator.

.....................................................................................................................

None It is not necessary to clear any authentication to send e-mails.

POP before SMTP It is necessary to first clear POP authentication to use the SMTP server to send e-mails.

SMTP It is necessary to clear authentication to send e-mails.

(4) [User name]

(5)

(6)

[Password]

[Sender mail address]

Enter the user name to access the server.

Number of characters for the user name: 1 to 32

Enter the password to access the server.

Number of characters for the password: 0 to 32

Enter the mail address of a sender.

The entered mail address is displayed in the "From" field of the sent mails.

Number of characters for the sender mail address: 3 to 128

50

Setting the FTP server [FTP]

Click the [FTP] tab on the "Server setup" page.

On this page, the settings for the FTP server that sends alarm images can be configured.

(1)

(2)

(3)

(4)

(5)

No.

Item

(1) [FTP server address]

(2) [User name]

(3) [Password]

(4) [Control port]

Default: 21

(5) [FTP mode]

Default: Passive

Passive

Active

Description

Enter the IP address or host name of the FTP server used to send images. To enter the host name for "FTP server address", it is necessary to configure the DNS settings on the [Network] tab of the "Network setup"

page. (

→ page 52)

Number of characters for the FTP server address: 1 to 128

Enter the user name to access the server.

Number of characters for the user name: 1 to 32

Enter the password to access the server.

Number of characters for the password: 0 to 32

Enter a control port number to be used for the FTP server.

Available port number: 1 to 65535

Select the FTP communication mode for when images are sent.

• Normally, select "Passive". When a connection cannot be established in the "Passive" mode, select "Active".

.....................................................................................................................

Sets the FTP communication mode to "Passive".

Sets the FTP communication mode to "Active".

51