advertisement
STEP 11. INSTALL CROP
DIVIDERS
A. D60
UNLOADING AND ASSEMBLY
D
E d. Lift forward end of divider until pin (C) at top of divider engages, and closes latch (D). e. Push safety lever (E) down to lock pin in latch. a. At divider storage location, remove shipping wire from crop divider.
B
A b. Lift divider to disengage lugs (A) at lower end, and then lower it slightly to disengage pin (B) from endsheet.
F f. Check that divider does not move laterally. Adjust bolts (F) as required to tighten divider, and remove lateral play when pulling at divider tip. g. Remove divider rods from shipping location on header endsheet.
A
H
C c. Position crop divider as shown by locating lugs (A) in holes in endsheet.
Form 169007
25
G h. Position divider rod (G) on tip of crop divider as shown, and tighten bolt (H). i. Repeat above steps for other end of header.
Revision C
UNLOADING AND ASSEMBLY
B. D50
A
A
B a. Remove bolt (A), and washer securing crop divider to endsheet. d. Install bolt (A), lock-washer, and flat washer.
Tighten bolt.
B b. Lift divider to disengage lugs (B) at lower end.
B
C bolts (C) as required to tighten divider and remove lateral play when pulling at divider tip. f. Remove divider rods from shipping location on header endsheet. c. Position crop divider as shown by locating lugs (B) in holes in endsheet forward end, and lift forward end of divider to face of endsheet.
E
D g. Position divider rod (D) on tip of crop divider as shown, and tighten bolt (E). h. Repeat above steps for other end of header.
Form 169007
26
Revision C
advertisement