Lubricate Unit. Ariens 921025

IMPORTANT: More frequent service may be required in extreme conditions (heavy loads, high ambient temperatures, dusty conditions or airborne debris).

LUBRICATE UNIT

Ariens recommends using Ariens Hi-Temp

Grease or equivalent (see Service Parts on page 18) to lubricate fittings. Lubricate each

season or every 25 hours of operation.

IMPORTANT: Wipe each fitting clean before and after lubrication.

IMPORTANT: DO NOT allow grease or oil to contact friction disc, swing gate or belts.

Use the following key for all lubrication procedures.

U-Joint

See Figure 26.

*

Grease

Oil

*

= Lubricate on Both Sides

Drive Chains

1. Remove hardware retaining left brush

cover and remove cover. See Figure 25.

2. Lubricate entire chain lengths.

Casters

See Figure 27.

Figure 26

Figure 25

3. Reinstall brush cover and secure with four tapping screws and four hex bolts.

*

*

Figure 27

EN - 19