7.

PABX Configuration using the web interface

Your PABX (Phone System) can be completely configured via the web management system.

The web management Welcome page contain a link to Basic PABX

Settings, which are the configuration options that the user will most likely wish to change.

The Basic PABX Settings are:

Incoming Ringing

Extension Names

Outgoing Restriction

Extension Class of Service

Cordless Registration

Line Forwarding

Instruction for setting these basic options are given below.

Additional instructions are also included for all other PABX configuration options. These may be accessed by selecting PABX

Configuration from the main menu and then using the sub-menu below to access individual functions.

Some programming changes require the system to be restarted. A prompt, shown below, will appear on the left-hand side of the screen. The Restart must be selected before you exit to ensure the settings take effect.

Incoming Ringing

By associating lines with individual extensions, you can have lines ringing different extensions in Day and Night modes.

For example, in DAY mode, all calls on line1 might ring all phones, but in NIGHT mode all calls on line 1 might be set to only ring extension 20.

Also, in both DAY & NIGHT modes, all calls on IP Trunk (VoIP) 1 might be set to ring on extension 23 only.

94

To change the settings, select ON or OFF from the relevant drop down box for the Line/Extension configuration you require.

The default is that ALL lines ring ALL wired extensions and the first four cordless phones in both Day and Night Modes.

95