Print settings. Canon PIXMA TS6050, Pixma TS6000 series, PIXMA TS6052, PIXMA TS6040

Print settings

• Prevent paper abrasion

Use this setting only if the print surface becomes smudged.

Important

• Be sure to set this back to OFF after printing since it may result in lower printing speed or lower print quality.

• Extended copy amount

Selects the amount of image that extends off the paper when printing in borderless (full).

Slight cropping may occur at the edges since the copied image is enlarged to fill the whole page. You can change the width to be cropped from the borders of the original image as needed.

Important

• This setting can be applied under the following conditions:

- Performing borderless copying

- Borderless is selected for Border when copying printed photos

Note

• If printouts contain margins even though you are printing in Borderless, specifying Extended

amount: Large for this setting may help solve the problem.

• Auto photo fix setting

When ON is selected, you can select whether to print photos using the Exif information recorded in the image files when Default* or On is selected in printing with a PictBridge (Wireless LAN) compliant device.

* When Default is selected for the print setting on the PictBridge (Wireless LAN) compliant device, select Auto photo fix for Photo fix in PictBridge print settings.

• Adjust horizontal print position

Adjusts the print position when the left/right margins are not aligned.

You can adjust the left/right margins in increments of 0.01 inch/0.1 mm between -0.12 inch/-3 mm and

+0.12 inch/+3 mm centered on the horizontal center of the paper.

Important

• For Letter-sized or Legal-sized paper, you can adjust the left/right margins between -0.06 inch/-1.5

mm and +0.06 inch/+1.5 mm even if you specify the value over 0.06 inch/1.5 mm.

133