Front-Loading Dryer

A

As the inside of the dryer will be excessively hot when you cancel the program when the dryer is running, activate the ventilation program to cool it down.

A

If the dryer is stopped during any drying program, and if the position of the program selector knob is changed, a tone will be heard (if the Cancel Audio Warning function is not selected). The dryer will not start even if the Start/Pause/

Cancel button is pressed, unless the program selector knob is returned to the initial program.

The paused program must be cancelled in order to change the drying program.

5.9 Adding/removing laundry in stand-by mode

In order to add or take out laundry after the start of the program;

1. Press the Start/Pause/Cancel button to switch the dryer to Pause mode. the drying process will stop.

2. Open the door at the Pause position and close it again after adding or taking out laundry.

3. Press the “Start/Pause/Cancel” button to restart the program.

C

Laundry may be added or taken out during a drying process, but interrupting drying continuously will extend the program’s time and increase energy consumption.

Therefore, it is recommended to add all laundry before the drying program is started.

5.10 Auxiliary functions

Cancel Audio Warning Signal

Your dryer will send out a tone when the program comes to an end. If you do not want to hear this, you need to press the Cancel

Signal button. The relevant lamp will light when this button is pressed and the tone will not activate when the program ends.

C

You can select this function either before or after the program starts.

5.11 Child-proof lock

There is a childproof lock to prevent any program interruption due to the pressing of keys while a program is running. The loading door and all buttons except the “On/Off” key on the panel are deactivated when the childproof lock is active.

In order to activate the childproof lock, pres the Start/Pause/Cancel and Cancel Audio

Warning buttons at the same time for 3 seconds.

To start a new program after the program ends or to stop a program, the childproof lock should be deactivated. To deactivate the childproof lock, press the same two buttons for 3 sec.

C

Child Lock

2 beeps when activating and 1 beep when deactivating the childproof lock will be heard.

Dryer / User Manual

20 / EN