advertisement
RS-232 Serial Port Pins
The E7-2 RS-232 serial port enables console connections to the E7-2 CLI, accessible via an
RJ-11 connector located on the E7-2 fan module (labeled MGT-4).
E7-2 Serial Port
RS-232 Signal
(From E7-2)
Serial Port
RJ-11F
TX
RX
GND
Pin 3
Pin 4
Pin 5
57
RJ-11F Connector
Calix offers an RS-232 console cable (DB-9F to RJ-11M) to connect a PC to the E7-2 serial port. Alternatively, you may use the pin assignments below to make your own console cable, as required.
Console Cable
RS-232 Signal
(From PC)
PC End:
DB-9F
E7-2 End:
RJ-11M
RX
TX
GND
Pin 2
Pin 3
Pin 5
Pin 3
Pin 4
Pin 5
DB-9F Connector
RJ-11M Connector
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
© Calix. All Rights Reserved.
advertisement
Related manuals
advertisement
Table of contents
- 8 Introducing the Calix E
- 10 Product Dimensions
- 12 Installation Guidelines
- 13 Safety Recommendations and Notices
- 14 Required Items
- 16 Preparations Before You Begin
- 18 Installing the E7-2 Chassis
- 21 Grounding the Chassis
- 23 Connecting DC Power
- 24 Installing the Fan Module
- 26 Installing E7-2 Line Cards
- 28 Installing a Fiber Guide
- 31 Installing an Intake/Exhaust System
- 34 Connecting the E7-2 Management Interfaces
- 34 Connecting to the Ethernet Management Ports
- 36 Connecting to the RS-232 Serial Port
- 37 Wiring the External Alarm and Timing Interfaces
- 37 Wiring External Alarms
- 39 Wiring the BITS Timing Interface
- 41 Connecting the E7-2 Line Interfaces
- 42 Installing Pluggable Transceiver Modules
- 43 Connecting Fibers
- 44 Connecting to the Copper Access Interfaces
- 48 Replacing Pluggable Transceiver Modules
- 49 Replacing an E7-2 Line Card
- 50 Replacing the Fan Module
- 51 Fan Filter Maintenance
- 54 E7-2 Specifications
- 55 E7-2 LED Behavior
- 57 RS-232 Serial Port Pins
- 58 RJ-21 Pin Assignments
- 60 Fiber Handling Techniques