advertisement
To adjust Proxy Checker settings click the “Test Settings...” button.
The following options are available:
Work through Proxifier — Proxy Checker will bypass Proxifier when this option is disabled. This is the default value and it should only be changed in a very special scenario (e.g. the target proxy is not directly accessible).
Target host and Port — set the target host for the test connection.
Load a default web page from the host — enable to test data transfer.
You can enable/disable particular tests.
You may use and distribute Proxy Checker as a standalone application (ProxyChecker.exe).
Proxy Checker is free for personal and noncommercial use.
Proxifier System Settings
Standard Edition only
Proxifier Standard Edition uses Winsock Layered Service Provider (Winsock LSP) to capture
TCP connections and Winsock Name Space Provider (Winsock NSP) to handle name resolution over proxy. Both providers have to be properly installed in the system. Normally this is done once automatically during Proxifier installation. Proxifier checks the configuration on each start.
If a problem is detected you will be prompted to resolve it automatically. It is highly recommended to fix the problem before using Proxifier.
Proxifier v3 for Microsoft Windows © Initex
Page 35
All Proxifier system settings are done with the System Settings tool
(Star->Programs->Proxifier->System Settings). Technically the tool consists of the
SysSettings32.exe and SysSettings64.exe programs for the 32- and 64-bit subsystems respectively.
Most commonly the cause of the problem is a third-party software that uses Winsock LSP and conflicts with Proxifier. We did our best to maximize Proxifier compatibility in v3, but, unfortunately, some conflicts may still exist.
In some cases you may need to run the System Settings tool manually.
Depending on the current state of the system settings you can Install, Uninstall and Repair the
Proxifier module.
Proxifier v3 for Microsoft Windows © Initex
Page 36
advertisement