ALEOS 4.8.0 Software Configuration User Guide for AirLink MP70
If you need to change the port for Telnet (for example, you have the default port blocked on your firewall), the option is on the Services > Telnet/SSH tab. The default Telnet port is 2332. You can also change the Telnet timeout; if the connection is idle, default timeout is 2 minutes. This is the internal Telnet on the device to pass AT commands and not TCP PAD.
AT commands are shown in upper case, but they are not case sensitive.
This appendix organizes the commands into functional groups to allow you to more quickly locate a desired command when you know the operation but not the command. Commands under each topic are listed alphabetically.
Note: Some of the configuration commands listed here are only available as AT commands.
Reference Tables
Result codes are not shown in the command tables unless special conditions apply. Generally the result code
OK is returned when the command has been executed.
ERROR may be returned if parameters are out of range, and is returned if the command is not recognized or is not permitted in the current state or condition of the AirLink gateway.
Note: Unless otherwise stated, all commands are accessible locally and remotely.
AT command topics in this appendix:
•
Standard (Hayes) commands on page 486
•
Device Updates on page 429
•
Status on page 430
•
WAN/Cellular on page 436
•
LAN on page 454
•
Wi-Fi on page 457
•
VPN on page 462
•
Security on page 468
•
Services on page 469
•
Location on page 479
•
Serial on page 486
•
I/O on page 497
•
Applications on page 497
•
Admin on page 501
428 41110546
