AT Commands
Device Updates
Table D-1: Device Update AT Commands
Command Description
*FWRMUPDATE
I4
*RCVRUPDATE
This AT command updates the ALEOS software and, if required the radio module firmware, remotely.
The ALEOS software file must be on an ftp server.
The command parameters are:
AT*FWUPDATE= <FTP Server IP>,<FTP Server username>,<FTP Server password>,<ALEOS filename>[,<Radio module firmware filename>]
Example:
AT*FWRMUPDATE=192.168.17.111,MyUserName,v3yieo,GX_4.3.4.001v0.bin,MC8705_OSM
001_T1043D.bin
Error messages:
•
Firmware update failed: could not get file from FTP server—Firmware file does not exist; check that the file name was spelled correctly
•
RM file is required—the update you are attempting requires a radio module update
Query the Recovery version installed on the gateway
Example:
ATI4?
returns 2.0 - 31934
Use this AT command to install or update the Recovery manager. (See Recovery Mode on page 18.)
The Recovery Manager file (available from source.sierrawireless.com
) must be on an ftp server.
The command parameters are:
AT*RCVRUPDATE= <FTP Server IP>,<FTP Server username>,<FTP Server password>,<Recovery manager filename>
Example:
AT*RCVRUPDATE=192.168.17.111,MyUserName,v3yieo,uImage.recovery.bin
Rev 1 Apr.17
429
