OM, Gardena, 9332, 9334, ErgoJet 3000, ErgoJet 2500, Electric

8

7

2

9

0

6

Attaching the collection bag:

NOTE: A safety switch will prevent the unit from starting if the elbow tube

7

is not installed correctly.

1. Align the grooves on the elbow tube blower outlet

2

.

7

with the grooves on the

2. Press the elbow tube into place.

8

.

7

onto the blower outlet

2

until it snaps

The collection bag is secured to the blower outlet with the tube release button

3. Clip the collection bag tube 

6

.

9

into both loops

0

on the vacuum

To remove the collection bag and pull out the elbow tube

9

, press the tube release button

8

7

at the same time.

Attaching the shoulder strap:

For extra support when using your unit as a vacuum, a shoulder strap is included with your unit. Attach the strap to the unit before operation. Snap the hook onto the retainer q

.

q

3. Operation

Cables:

WARNING:

Do not use the unit without the tubes or collection bag properly attached to avoid flying debris and/or impeller contact which can cause serious

injury. Always wear gloves and use eye protection to prevent rocks or debris from

being blown or ricocheting into the eyes and face which can result in blindness or serious injury.

Use only 1.00mm

2 size cable up to 40 metres length maximum.

Maximum rating:

1.00mm

2 size cable

ErgoJet 3000 (EJ3000): 3000 W

ErgoJet 2500 (EJ2500): 2500 W

Mains cables and extensions are available from your local

approved service centre. Only use extension cables specifically designed for outdoor use.

21

Connecting the unit:

Starting the unit:

r t

Working positions:

WARNING! To avoid damage to the plug, the extension cable must be inserted into the cable lock.

e e w w

1. First make a loop with the extension cable into the cable lock w

, thread the loop e

and pull the extension cable tight.

2. Connect the unit’s plug to the extension cable.

3. Connect the extension cable to a 230-V mains socket.

To start:

v Move the ON/OFF switch

The unit starts.

r

to the ON position.

NOTE: For ErgoJet 3000 (EJ 3000) only: The motor speed can be increased or decreased by using the variable speed control t

.

CAUTION: To avoid causing damage to the unit, only use the

variable speed control in blow mode. DO NOT attempt to use the variable speed control in vacuum mode. Lower speeds during vacuum use could allow debris to build up, stall the motor and cause unit failure.

To stop:

v Move the ON/OFF switch

The unit stops.

r

to the OFF position.

Blow mode

Use your unit as a blower for sweeping debris or grass clippings from driveways, sidewalks, patios, etc. Also, for blowing grass clippings, straw, or leaves into piles, or removing debris from

corners, around joints, or between bricks.

For ErgoJet 3000 (EJ 3000) only:

Use the variable speed control to increase or decrease the motor speed during blower use.

Direct air flow by directing the blower tube down or to one side.

Always work away from solid objects such as walks, large stones, vehicles, and fences.

Clean corners by starting in corners and moving outward. This will help prevent an accumulation of debris which could fly into your face. Be careful when working near plants. The force of the air could damage tender plants.

22