advertisement
Ready Light
The ready light is “on” when the system is ready to arm and “flashes” if ready to force arm. The ready light is off when the system is not ready to arm because of a zone(s) being faulted.
Stay Light
The stay light is “on” when the all interior (motion detector) zones are bypassed.
Zone Light
The zone lights are “off” when everything is normal. A zone light will be “on” if the zone has been bypassed. If a zone light is “flashing”, that zone is in alarm or has been faulted. If a zone light is “flashing” rapidly, it means that the zone is in a trouble condition. Trouble conditions are:
Tamper Hardware Low Battery Loss of Supervision
(A combination of Alarm/Fault and Tamper/Trouble will produce a rapid
“flashing” light for a short period of time, follow ed by a slow “flashing” light.)
EMERGENCY ACTIVATION KEYS
NOTES: You must hold these keys for 2 seconds to activate these functions. Your system may not be programmed for these activation keys
(see page 1). You should press these keys only in an emergency situation that requires response by emergency personnel. If your system is programmed for these functions, the following reports can be sent.
Fire Key – This key can activate the fire alarm when pressed for 2 seconds. If your system is connected to a monitoring center, an emergency report could be sent to that center. The keypads sound a continuous beeping.
Auxiliary Emergency Key – This key can activate the auxiliary alarm when pressed for 2 seconds. If your system is connected to a monitoring center, an emergency report could be sent to that center. The keypads sound a continuous beeping.
Police (Panic/Hold-Up) Key - This key can sound a local audible alarm when pressed for 2 seconds. If your system is connected to a monitoring center, an emergency report could be transmitted to that center. NOTE: Some Panic/Hold-
Up alarms are programmed to be silent at the protected site while reporting an alarm to the monitoring center. Check with your installing company to determine how your security system will respond to the Panic/Hold -Up activation. If programmed for Silent Hold-up, the keypads will not sound.
Otherwise, the keypads will sound a continuous beeping.
6
advertisement
Related manuals
advertisement
Table of contents
- 6 GLOSSARY OF TERMS
- 7 UNDERSTANDING THE LIGHTS
- 7 Armed Light
- 7 Bypass Light
- 7 Cancel Light
- 7 Chime Light
- 7 Exit Light
- 7 Fire Light
- 7 Instant Light
- 7 Power Light
- 8 Ready Light
- 8 Stay Light
- 8 Zone Light
- 8 EMERGENCY ACTIVATION KEYS
- 9 KEYPAD FUNCTIONS
- 9 Arming Your System In The “Away” Mode
- 9 Arming Your System In The “Stay” Mode
- 10 Using The Quick Arm
- 10 Disarming The System
- 11 Cancel / Abort Feature
- 11 Bypassing Zones
- 11 Group Bypass
- 11 Unbypassing
- 11 Turning The Door Chime On And Off
- 12 ASSIGNING USER CODE AUTHORITY LEVELS
- 14 OTHER KEYPAD FUNCTIONS
- 14 Setting The Keypad Tone
- 14 Change Partition
- 14 View Alarm Memory
- 14 Test Function
- 14 Walk Test
- 15 Reset Function
- 15 Set System Date
- 15 Setting The System Clock
- 16 KEYPAD CONTROL TONES (BEEPS)
- 17 SERVICE MENU
- 18 EMERGENCY EVACUATION PLANS