NX LED Keypad USER MANUAL

Step 3 x Press the [STAY] key.

x The stay light will illuminate indicating that all interior zones are bypassed. (All interior devices will bypass automatically, giving the user freedom of movement within the interior area.) x The bypass light will illuminate if any zone(s) are bypassed. If any zone(s) have been bypassed previously by the user, the light(s) corresponding to the bypassed zone(s) will illuminate, ale rting the user that a zone(s) may be unprotected and can be faulted without an alarm.

Step 4 x To toggle from a “delayed entry” mode to an “Instant” mode, press the [STAY] key again.

x The instant light will illuminate indicating that the entry/exit doors have no entry delay.

USING THE QUICK ARM (Optional, see page 1)

The Quick Arm feature may be used if it is enabled. Quick Arm will allow the user to arm the security sys tem in the AWAY mode by pressing the [EXIT] key, or arm in the STAY mode by pressing the [STAY] key. The keypads beep during the exit delay; beeps rapidly for the last 10 seconds of the exit delay; and beeps

1 second at the end of the exit delay. This feature is used for ARMING ONLY, and will not disarm the security system. This is ideal for a maid or baby sitter code, etc.

CHANGING MODES WHILE SYSTEM IS ARMED

the doors and turn on/off (toggle) the instant light.

ƒ (Optional) Press the [BYPASS] key at this time to turn on/off (toggle) all designated interior zones.

ƒ (Optional) When armed, pressing the [EXIT] key will start the exit delay, enabling you to leave the building.

IMPORTANT

The instant light needs to be off at this time if you plan on re -entering the building; otherwise you will create an alarm. You may restore an entry delay by pressing the [STAY] key again.

DISARMING THE SYSTEM

When you enter the protected area through one of the designated Entry/Exit doors, the keypad control will sound a continuous tone for the duration of the entry delay time, or until you enter a valid code. The red armed light will go off and the tone will stop. The security system is now DISARMED. If a valid code is not entered before the end of the entry delay, an alarm will occur. (NOTE: If the

red armed light is flashing during the entry delay, the alarm system has been activated in your absence. Leave the building immediately and call your

alarm company and/or the police from a safe location.)

8