General Operation. Panasonic TX-47P950A

10

General Operation

STR F

Power switch

STR

Used to store tuning and other function settings. Also used to start the menu demonstration.

Function selection

Displays the on screen display functions, use repeatedly to select from the available functions.

The following adjustments can be accessed directly.

VOLUME

CONTRAST

BRIGHTNESS

COLOUR

SHARPNESS

TUNING MODE

BALANCE

TREBLE

BASS

TINT

Notes:

• TINT:

Displayed when receiving NTSC and YUV625i signals.

• TUNING MODE :

Not displayed during AV mode.

TV/A V

TV/AV Selection

Press to select TV, AV1, AV2, AV3 and AV4 input signal modes sequentially.

Volume Up (+) / Programme Number Up ( )

Volume Down (-) / Programme Number Down ( )

Sound Mute

Press to mute the sound completely the “Mute” symbol will appear.

Press again to restore the previous sound level, and cancel the mute.

Stereo/Bilingual Sound Selection

(see page 34)

R-Tune

Press to switch to previously viewed channel or input mode.

Volume Adjustment

Press to increase or decrease the sound volume level.

Menu

Press to access the PICTURE, SOUND and SETUP menus.

(see page 13, 23-26)

Coloured buttons used for

Multi Screen functions (see page 29)

Teletext functions (see page 31)

AV selection (see page 11)

TV/TEXT Selection

(see page 31)

TEXT Favorite Page Selection

(see page 32)

Recall

Press to display the current system status, for example, Programme number, Channel number, Stereo mode, Picture menu, Sound menu,

Scan mode, Sound system and colour system.

REC

General Operation

Power (Stand-by) (see page 6)

The TV set must first be plugged into the wall outlet and turned on at the power switch.

Press this button to turn the TV set On from Standby mode, press it again to turn the TV set OFF to

Standby mode.

Note:

• It is also possible to turn the TV set on from STANDBY mode by pressing the “Direct Programme Number Selection” Buttons (0-9) and the “Programme Number Up or Down” Button, either on the set or on the Remote Control.

Off timer (see page 23)

Multi Screen (see page 29)

Aspect (see page 28)

Surround (see page 26, 27)

Normalization (see page 25, 27)

Programme Number Selection

Press to select the next higher or lower Programme number.

Press to store settings in Tuning menu.

TV/AV Mode Selection

Press to select TV, AV1, AV2, AV3 and

AV4 input signal modes sequentially.

Remote control :

AV1 AV2 AV3

TV/AV

AV4

Press to display AV1 - AV4 at the bottom of the screen. Each coloured button corresponds to each input signals.

For example, pressing the Red button selects AV1.

5

VCR DVD

TEXT hold (see page 32)

/Still (see page 29)

TEXT Index (see page 33)

/Channel Search (see page 30)

Direct programme Number

• Direct Programme Number Selection

You can select the number directly by pressing the corresponding programme number buttons.

Programme Number 8......

8

Programme Number 36....

3 6

Programme Number 124...

1 2 4

Note:

• When the Skip setting for Programme

Number 100 through 125 is on, the channel selection time will be shortened, and thus you can not input three digits at a time.

VCR/DVD CONTROL

(see page 34)

TV

11