Aspect Controls
AUTO
ASPECT
MULTI PIP
SURROUND ASPECT
R-TUNE N
AUTO 16:9 14:9 JUST
ZOOM3 ZOOM2 ZOOM1 4:3
OK
MENU TV/AV
TV/TEXT F.P.
INDEX HOLD
Notes:
• Simply press ASPECT
ASPECT
to display mode information in the top left of the screen. Whilst the on screen selector keys are displayed, use the Red or Green buttons to move in either direction through the eight aspect options.
• 16:9 picture has been used to illustrate all of the aspect modes described in this section.
CH SEARCH STILL
The on screen selector keys (corresponding to the four coloured buttons on the remote control) appear for some Aspect functions and disappear after a few seconds. If you would like to select an operation when the keys are not shown, press ASPECT
ASPECT
once more and the keys will reappear.
Helpful Hint (
N
Normalization)
By pressing the Normal “N” Button on the Remote Control while the Aspect menu is displayed, the selected menu will be changed to the Normal Mode.
Normalization will not occur if the menu is not displayed when the “N” Button is pressed.
The Normal mode is the factory preset condition. Returning to this original condition is called “Normalization”.
Mode Picture
Press to select the different Aspect options.
Explanation
The AUTO position can be set to 16 : 9. When a wide screen signal is detected at the Video terminal the TV will select the 16:9 aspect ratio.
16:9 Signal 4:3 Signal
16 : 9
The 16:9 option will display the picture at its maximum size. Signals in the 4:3 format will be stretched to fit the picture.
16:9 Signal 4:3 Signal
14 : 9
The 14:9 option will display a 4:3 signal in simulated wide screen. The picture is slightly stretched. It is also slightly cropped top and bottom.
JUST
4 : 3
JUST gives you a best fit option when showing
4:3 on wide screen. The centre of the picture is not affected but there is some stretching at the edges.
This option will display a standard 4:3 picture without any stretching or compression. There will be vertical gray lines down either side of the picture.
This option allows you to magnify the picture.
ZOOM1
ZOOM1
ZOOM2
ZOOM2,
ZOOM3
The picture becomes larger and larger when you change the mode ZOOM2 and ZOOM3.
Notes:
• ASPECT operations cannot be made during progressive (Y, P
B
, P
R
) or 1080i signal input.
28