advertisement
Installation and setting up
DANGER! DO NOT operate the smoke machine until you have read and observed all the precautions listed under “Safety information” on page 3.
L o c a t i o n
The smoke machine may be located on the floor or may be suspended using the flying bracket.
The machine can operate in any orientation from 45 degrees upwards to 45 degrees downwards. Steeper tilting may cause fluid leakage.
If the machine is to be suspended, ensure the mounting surface can support the weight of the machine. Do not suspend the machine over areas where people will be underneath.
Ensure that there is at least 100mm clearance all round the machine and at least
600mm in front of the smoke output.
A C p o w e r
Before using the machine, ensure that a grounding-type (earthed) power plug that fits the local power outlets is installed on the power cable.
DANGER! Make sure the power plug is correctly rated:
• For EU (230V) use fit a plug rated 10 amp minimum
• For US (120V) use fit a plug rated 16 amp minimum
When installing the plug, follow the plug manufacturer’s instructions and connect pins as follows: yellow and green wire to ground (earth), blue wire to neutral and brown wire to live.
The table below shows some common pin identification schemes. brown live “L” yellow or brass
8 green/yellow earth green
Before connecting the smoke machine to power, verify that the AC supply is adequately dimensioned for the current draw of the machine. The machine requires:
8.21A at 230V (EU)
14.58A at 120V (US)
Check that the local AC voltage is appropriate, as indicated on the machine’s serial number label. If your AC voltage is outside the appropriate range, do not use the machine. Contact Martin Service for assistance.
Installation and setting up
advertisement
Related manuals
advertisement
Table of contents
- 3 Safety information
- 6 Product overview
- 6 Product description
- 6 Features at a glance
- 7 Quick Start
- 7 Setting up
- 7 Making fog
- 8 Installation and setting up
- 8 Location
- 8 AC power
- 9 Setting up
- 9 Final checks
- 9 Turning on the power
- 10 Control settings
- 10 Overview
- 10 Manual firing
- 10 Setting fog output level
- 10 Setting the timer
- 10 Priming the machine after fluid out
- 11 DMX control
- 11 Overview
- 11 Connection
- 11 DMX functions
- 12 Setting the DMX address
- 13 Fog fluid types
- 14 Basic service
- 14 Cleaning
- 14 Fuse replacement
- 15 Troubleshooting
- 16 Specifications