- No category
advertisement
1.15
Accessories
The following accessories are available for use with the SMD41/42.
MM3101
Heat Sink Plate 100 x 160 x 15 mm. Thermal resistance 1K/W.
The Heat Sink Plate is ready for mounting in a 19" rack. Screws for mounting the SMD41/
42 are included.
MM3101 is suitable for all models of the SMD41/42.
MM3103
Heat Sink Plate 100 x 114 x 67.5 mm. Thermal resistance better than 0.6K/W.
The Heat Sink Plate is ready for "wall" mounting. Screws for mounting the SMD41/42 are included. MM3103 is suitable for all models of the SMD41/42.
Heatsink for 19” rack mounting type MM3101
Heatsink for “wall” mounting
type MM3103
TT0019
RP0001
CS0002
SMI30
Cables
Power dump resistor 33 Ohm/50W. Dimensions: 16x50x16mm excluding connection terminals and mounting flanges.
14-pole Connector. This connector is always mounted on the SMD41/42 on delivery and is standard.
If the connector is lost or becomes damaged, a new one can be ordered using this number.
Step Motor Indexer. The SMI30 is a programmable Indexer which can be used as a standalone unit for executing user programs for motor control using positioning and various speeds. The SMI30 is based on a motor processor that can generate step pulse frequencies up to 2MHz. See
Connection to Indexer SMI30,
page 23, for further details.
JVL can supply customised cables for specific applications. Contact JVL for further information.
JVL Industri Elektronik A/S — User Manual Step Motor Driver SMD41/42 25
advertisement
Related manuals
advertisement
Table of contents
- 6 Introduction
- 7 Driver Connections
- 8 Power Supply
- 9 Adjustment of Motor Phase Current
- 11 Connection of Motor
- 14 Step Pulse and Direction Inputs
- 16 Error Output
- 17 Selection of Curve Forms
- 18 Selection of Step Resolution
- 19 1.10 Physical Dimensions
- 20 1.11 Technical Specifications
- 21 1.12 Motor Connections
- 23 1.13 Connection to Indexer SMI
- 24 1.14 Connection to PLC / PC Boards
- 25 1.15 Accessories
- 26 1.16 CE Declaration of Conformity