- Industrial & lab equipment
- Electrical equipment & supplies
- Power generators
- Wacker Neuson
- GPi 1700
- User manual
advertisement
Operation
2.13
Starting the Generator
GPi 1700
CAUTION
Personal injury or machine damage hazards. Starting the generator with equipment attached can damage the generator or the equipment. Unexpected equipment start-up can cause personal injury.
f Disconnect all equpment from the generator before starting it.
Starting procedure
Follow the procedure below to start the machine.
1. Turn the engine switch (y) to the CHOKE position (or the RUN position if the engine is warm or the ambient temperature is high).
p a y wc_gr006656
2. Pull the recoil starter (a) slowly until you feel resistance.
3. After you feel resistance, return the recoil starter to its original position and pull quickly. The engine will start.
4. If you started the machine with the engine switch in the CHOKE position, allow the engine to run for 20–30 seconds and then turn the engine switch to the RUN position.
5. Check to make sure that the pilot indicator light (p) is illuminated. This indicates that the generator is operating properly.
Troubleshooting If the engine does not start after several attempts, repeat the starting procedure with the engine switch turned to the RUN position. If the engine still does not start, refer to the Troubleshooting chapter in this Manual.
28 wc_tx001234gb.fm
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 7 Signal Words Found in this Manual
- 8 Machine Description and Intended Use
- 9 Safety Guidelines for Operating the Machine
- 11 Operator Safety While Using Internal Combustion Engines
- 12 Guidelines for Service Safety
- 13 Label Locations
- 14 Machine Labels
- 17 Overview
- 17 Preparing the Machine for First Use
- 18 Features and Components
- 19 Lifting and Transporting
- 19 Installation
- 20 Power Requirements
- 21 Use of Extension Cords
- 22 Control Panel
- 24 Customer Connections
- 25 Grounding the Generator
- 26 Fueling the Machine
- 27 Before Starting
- 28 Starting the Generator
- 29 Using AC Power
- 30 Using DC Power
- 31 Stopping the Generator
- 31 Emergency Shutdown Procedure
- 32 Periodic Maintenance Schedule
- 34 Cleaning and Checking the Spark Plug
- 35 Cleaning the Air Cleaner Assembly
- 36 Changing the Engine Oil
- 37 Cleaning the Spark Arrester
- 38 Cleaning the Fuel Filter
- 39 Storing the Generator
- 43 Schematic Components
- 45 Engine
- 46 Generator Data