Status. Bay Technical Associates BayTech DS71-MD4, DS72

DS72 Host Module

RPC/RPS External Environmental Sensor Configuration Menu

Sensor Number: All Name: all RPCs/RPSs Type: Humidity

1...High Threshold (tenths of meas. unit): NP

2...High Threshold Trap Enable: NP

3...Low Threshold (tenths of meas. unit): NP

4...Low Threshold Trap Enable: NP

Enter Request :

Select 4), from the probe type menu allows the administrator to set the High and Low Air Flow range.

Option 2 and 4 will enable/disable their corresponding SNMP traps.

RPC/RPS External Environmental Sensor Configuration Menu

Sensor Number: All Name: all RPCs/RPSs Type: Air Flow

1...High Threshold (tenths of meas. unit): NP

2...High Threshold Trap Enable: NP

3...Low Threshold (tenths of meas. unit): NP

4...Low Threshold Trap Enable: NP

Enter Request :

Host Module responds with the new values.

NOTE: the values are given in tenth of a degree, so the below values are 9.9 degrees for the high value and 6.0 degrees for the low value.

RPC/RPS External Environmental Sensor Configuration Menu

Sensor Number: All Name: all RPCs/RPSs Type: Temperature

1...High Threshold (tenths of meas. unit): 99

2...High Threshold Trap Enable: Enabled

3...Low Threshold (tenths of meas. unit): 60

4...Low Threshold Trap Enable: Enabled

Enter threshold value in tenths of unit measurement (degrees,%%,etc.):

NOTE: Selecting the values for the Humidity and Air Flow is the same the Temperature options.

Status

The option gives the current network status. The Host Module displays the following:

DS-72 Status Menu.

Enter selection, CR to exit.

1)...System

2)...Network Interface

3)...Logged Users

Enter Request :1

System

30