Using Pre-Printed Receipt Media. Zebra iMZ320, P1056757-001, iMZ220, MZ UG

Using Pre-Printed Receipt Media

iMZ series printers support alignment of pre-printed receipts by using the out of paper sensor located near the printhead.

Please be aware of the following factors:

1) Note the black bar location and dimensions as detailed below and in the Specifications section of this manual.

2) Complete information on using pre-printed media can be found in the FORM command topic in the CPCL

Programming Manual. The CPCL manual is available on the iMZ Product CD or on the Zebra Web site at http://www.zebra.com/manuals.

Figure 7: Media Black Bar Dimensions

3 inch media

(76.2 mm)

0.19 - 0.24 in.

(3,0 - 6,0 mm)

0.59 in.

(15 mm)

0.19 - 0.24 in.

(3,0 - 6,0 mm)

3 inch media

(76.2 mm)

0.59 in.

(15 mm)

16 iMZ Series User Guide

Figure 8: Installing Media

Media Roll

Note direction media pulls off the roll.

Figure 9: Closing the Media Cover

Pull a short length of media out of the Printer

Media Cover

Ensure both sides of the media cover are securely latched when closed.

17 iMZ Series User Guide