advertisement
Disassembling the LCD Module
1.
Remove the four screw caps as shown.
2.
Remove the four screws holding the LCD bezel.
3.
Then detach the LCD bezel from the LCD module.
4.
Disconnect the inverter board then remove it.
5.
Remove the three screws holding the right hinge.
6.
Then remove the three screws that secure the left hinge.
.
7.
Remove one screw that secure the LCD bracket.
8.
Remove another screw holding the LCD bracket on the other side.
9.
Then detach the LCD panel from the LCD cover carefully.
10. Remove the two screws holding the right bracket.
11. Then remove the right bracket.
12. Remove another two screws that tighten the left bracket.
Chapter 3 64
13. Remove the left bracket as the picture shows.
14. Tear off the tape fastening the LCD cable.
15. Tear off the the LCD cable fastening the LCD cable, then remove it..
65 Chapter 3
advertisement
Related manuals
advertisement
Table of contents
- 1 Aspire 1410/1680 Series
- 2 Revision History
- 3 Copyright
- 4 Conventions
- 5 Preface
- 7 Product Comparision
- 9 Table of Contents
- 11 Ch.1 System Introduction
- 11 Features
- 13 System Block Diagram
- 14 Board Layout
- 14 Top View
- 15 Bottom View
- 17 An Aspire Tour
- 17 Front View
- 18 Closed Front View
- 19 Left View
- 20 Right View
- 21 Rear Panel
- 22 Bottom Panel
- 23 Indicators
- 25 Using the Keyboard
- 25 Lock Keys
- 26 Embedded Numeric Keypad
- 27 Windows Keys
- 28 Hot Keys
- 30 Special Key
- 31 Launch Keys
- 33 Touchpad
- 33 Touchpad Basics
- 35 Hardware Specifications and Configurations
- 46 Ch.2 System Utilities
- 46 BIOS Setup Utility
- 47 Navigating the BIOS Utility
- 48 Information
- 49 Main
- 51 Advanced
- 53 Security
- 57 Boot
- 58 Exit
- 59 BIOS Flash Utility
- 60 Ch.3 Machine Disassembly and Replacement
- 61 General Information
- 61 Before You Begin
- 63 Disassembly Procedure Flowchart
- 65 Removing the Battery Pack
- 66 Removing the HDD Module/the Memory and the Wireless LAN Card/ the Thermal Module and the CPU/ODD ...
- 66 Removing the HDD Module
- 66 Removing the Memory and the Wireless LAN Card
- 66 Removing the Thermal Module and CPU
- 68 Removing the ODD Module
- 68 Removing the LCD Module
- 70 Disassembling the Main Unit
- 70 Separate the Main Unit Into the Upper and the Lower Case Assembly
- 70 Disassembling the Upper Case Assembly
- 71 Disassembling the Lower Case Assembly
- 74 Disassembling the LCD Module
- 76 Disassembling the External Modules
- 76 Disassembling the Optical Drive Module
- 78 Ch.4 Troubleshooting
- 79 System Check Procedures
- 79 External Diskette Drive Check
- 79 External CD-ROM Drive Check
- 79 Keyboard or Auxiliary Input Device Check
- 80 Memory check
- 80 Power System Check
- 82 Touchpad Check
- 83 Power-On Self-Test (POST) Error Message
- 84 Index of Error Messages
- 87 POST Code
- 88 Index of Symptom-to-FRU Error Message
- 91 Intermittent Problems
- 92 Undetermined Problems
- 93 Use NAPP CD to Build Master Hard Disc Drive
- 93 CD to Disk Recovery
- 96 Disk to Disk Recovery
- 100 Ch.5 Jumper and Connector Locations
- 100 Top View
- 102 Bottom View
- 104 Ch.6 FRU (Field Replaceable Unit) List
- 105 Exploded Diagram
- 118 App.A Model Definition and Configuration
- 118 Model Name Definition
- 120 App.B Test Compatible Components
- 121 Microsoft Windows XP Environment Test
- 126 App.C Online Support Information
- 128 Index