advertisement
CH-506TXPL & RXPL
HDBaseT™ Lite HDMI over Single CAT5e/6/7 Extender with PoE
DISCLAIMERS
The information in this manual has been carefully checked and is believed to be accurate. Cypress Technology assumes no responsibility for any infringements of patents or other rights of third parties which may result from its use.
Cypress Technology assumes no responsibility for any inaccuracies that may be contained in this document. Cypress also makes no commitment to update or to keep current the information contained in this document.
Cypress Technology reserves the right to make improvements to this document and/or product at any time and without notice.
COPYRIGHT NOTICE
No part of this document may be reproduced, transmitted, transcribed, stored in a retrieval system, or any of its part translated into any language or computer file, in any form or by any means— electronic, mechanical, magnetic, optical, chemical, manual, or otherwise—without express written permission and consent from
Cypress Technology.
© Copyright 2011 by Cypress Technology.
All Rights Reserved.
Version 1.1 August 2011
TRADEMARK ACKNOWLEDGMENTS
All products or service names mentioned in this document may be trademarks of the companies with which they are associated.
SAFETY PRECAUTIONS
Please read all instructions before attempting to unpack, install or operate this equipment and before connecting the power supply.
Please keep the following in mind as you unpack and install this equipment:
• Always follow basic safety precautions to reduce the risk of fire, electrical shock and injury to persons.
• To prevent fire or shock hazard, do not expose the unit to rain, moisture or install this product near water.
• Never spill liquid of any kind on or into this product.
• Never push an object of any kind into this product through any openings or empty slots in the unit, as you may damage parts inside the unit.
• Do not attach the power supply cabling to building surfaces.
• Use only the supplied power supply unit (PSU). Do not use the PSU if it is damaged.
• Do not allow anything to rest on the power cabling or allow any weight to be placed upon it or any person walk on it.
• To protect the unit from overheating, do not block any vents or openings in the unit housing that provide ventilation and allow for sufficient space for air to circulate around the unit.
REVISION HISTORY
VERSION NO.
DATE DD/MM/YY SUMMARY OF CHANGE
VR0 18/01/13 Preliminary Release
VS1 04/07/13 Updated format/diagrams
CONTENTS
1. Introduction ............................................ 1
2. Applications ........................................... 1
3. Package Contents ................................ 1
4. System Requirements ............................ 1
5. Features .................................................. 2
6. Operation Controls and Functions ....... 3
6.1 Transmitter Front and Rear Panels ..3
6.2 Receiver Front and Rear Panels ......4
6.3 D-Sub 9-Pin Definitions ......................5
6.4 IR Cable Pin Assignment ..................5
7. Connection Diagram ............................ 6
8. Specifications ........................................ 8
9. Acronyms ............................................... 9
1. INTRODUCTION
This HDBaseT™ Lite HDMI over Single CAT5e/6/7 Transmitter and
Receiver Set can send uncompressed video and audio over a single run of CAT5e/6/7 cable up to 60 meters (1080p) or 35 meters (4K×2K) with the added benefit of control through the built-in RS-232 and 2-way
IR ports. The Power over Ethernet (PoE) function provides greater flexibility in installations.
2. APPLICATIONS
• Domestic HDMI installations
• University lecturing systems
• Retail showroom systems
• Conference presentation and control
3. PACKAGE CONTENTS
• 1×HDMI over Single CAT5e/6/7 Transmitter with PoE
• 1×HDMI over Single CAT5e/6/7 Receiver with PoE
• 1×IR Blaster
• 1×IR Extender
• 1×3.5 mm Mini-jack to RS-232 Female Cable
• 1×3.5 mm Mini-jack to RS-232 Male Cable
• 24 V/1.25 A DC Power Adaptor
• Operation Manual
4. SYSTEM REQUIREMENTS
HDMI source equipment such as a DVD or Blu-ray player and HDMI equipped display (TV or monitor). HDMI and CAT5e/5/7 connection cables.
1
5. FEATURES
• HDMI including 3D and 4k×2k (Ultra HD) support, HDCP and DVI compliant
• Supports HDCP repeater and CEC bypass functions
• Supports HDBaseT Lite Technology including 2-Way IR, RS-232 and
Power over Ethernet (PoE)
• Supports HD resolutions up to 1080p@60 Hz/36-bit and Ultra HD (4K×2K)
• Supports transmission distance of up to 60 meters through CAT5e/6/7 cable (1080p) or 35 meters (4K×2K)
• Supports HDMI input up to 15 meters at 8-bit resolution or 10 meters at 12-bit resolution and output up to 15 meters at 8-bit resolution and 10 meters at 12-bit resolution
• RS-232 with baud rate up to 115200/sec
• Supports wide range of IR frequency from 30 to 50 kHz
• Audio support up to LPCM 7.1CH, Dolby TrueHD, Dolby Digital Plus and DTS-HD Master Audio
• Installation friendly
Note
1. This system was tested with CAT-6E/23AWG cables, results may vary with cables of a different specification.
2. The PoE function is designed for powering compatible receiver units only—do not use with non-PoE receivers or receivers of another brand.
2
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Transmitter Front and Rear Panels
Front
IR2 Extender
RS232 In IR1 Blaster
HDMI In
DC 24V
7
Rear
Power
Link
Lite CAT 5e /6 Out
1 2 3 4 5 6 8
1 RS232 In: Connect to a PC/laptop or RS-232 control device
(with supplied 3.5 mm mini-jack to D-sub 9-pin adaptor) for the transmission of RS-232 commands.
2 IR2 Extender: Connect an IR extender cable for IR signal reception.
Ensure that remote control being used is within the direct line-ofsight of the IR extender.
3 IR1 Blaster: Connect an IR blaster cable for IR signal transmission.
Place the IR blaster in direct line-of-sight of the equipment to be controlled.
4 HDMI In: Connect to the HDMI source equipment such as a DVD or
Blu-ray player.
5 DC 24V: Connect the 24V DC power supply to the unit and plug the adaptor into an AC outlet.
6 Link LED: The yellow LED will illuminate when both the input and output CAT5e/6/7 signals are connected. The LED will blink when there is an error with the transmission signal.
7 Power LED: This green LED will illuminate when the device is connected to a power supply.
8 CAT5e/6 Out: Connect to the receiver unit with a single CAT5e/6/7 cable for transmission of all data signals.
3
6.2 Receiver Front and Rear Panels
Front
IR1 Extender
HDMI Out
RS232 Out IR2 Blaster
6
Rear
Power
Link
Lite
1 2 3 4 5
CAT 5e /6 In
7
1 RS232 Out: Connect to the device that is to be controlled (with the supplied 3.5mm mini-jack to D-sub 9-pin adaptor) by RS-232 commands
2 IR1 Extender: Connect an IR extender cable for IR signal reception.
Ensure that the remote being used is within the direct line-of-sight of the IR extender.
3 IR2 Blaster: Connect an IR blaster cable for IR signal transmission.
Place the IR blaster in direct line of sight of the equipment to be controlled.
4 HDMI Out: Connect to a HDMI equipped TV/monitor for display of the HDMI input source signal.
5 Link LED: This yellow LED will illuminate when both the input and output CAT5e/6/7 signals are connected. The LED will blink when there is an error with the transmission signal.
6 Power LED: This green LED will illuminate when the device is connected to a power supply.
7 CAT5e/6 In: Connect to the transmitter unit with a Single CAT5e/6/7 cable for transmission of all data signals.
4
6.3 D-Sub 9-Pin Definitions
6
7
4
5
PIN
1
2
3
8
9
DEFINE TX/RX
N/C
TxD/RxD
RxD/TxD
N/C
GND
N/C
N/C
N/C
N/C
6.4 IR Cable Pin Assignment
IR Blaster
1
2
3
Power 5 V
IR Blaster Signal
NC
IR Extender
1
2
3
IR Signal
Power 5 V
Grounding
5
7. CONNECTION DIAGRAM
Example 1: Direct Connection
RS-232 Equipped
PC or Notebook
3m 3m
60°
DVD/Blu-ray Player
1.5m
60°
IR Blaster 1
IR Extender 2
IR Extender 1
HDMI
Input
RS-232
Power Supply
IR2 Extender
RS232 In IR1 Blaster
HDMI In
DC 5V
Power
Link
CAT 5e /6 Out
TX
CAT5e/6/7
Cable (60m)
Power
Link
CAT 5e /6 In
IR1 Extender
RS232 Out IR2 Blaster
HDMI Out
RX
Powered over CAT Cable by PoE function
3m
60°
3m
1.5m
IR Blaster 2
60°
RS-232
HDMI
Output
RS-232 Device to be Controlled
Display
6
Example 2: Using a Repeater to Extend the Operating Distance
RS-232 Equipped PC or Control System
DVD/Blu-ray Player
60°
IR Blaster 1
IR Extender 2
1.5m
60°
HDMI
Input
RS-232
Power
Supply
IR2 Extender
RS232 In IR1 Blaster
HDMI In
DC 24V
Power
Link
Lite CAT 5e /6 Out
TX
CAT5e/6/7
Cable (60m)
Optional HDBaseT
Repeater (60m)
POWER
DC 24V
MODE
CAT5e/6 IN
LINK
HDBaseT Repeater
CHDBX-1C
MODE
CAT5e/6 OUT
LINK
Rear
Front
Power
Supply
RS-232 Device to be Controlled
RS-232
CAT5e/6/7
Cable (60m)
Power
Link
CAT 5e /6 In
IR1 Extender
RS232 Out IR2 Blaster
HDMI Out
RX
IR Extender 1
HDMI
Output
60°
1.5m
IR Blaster 2
3m
60°
3m
HDTV
7
8. SPECIFICATIONS
Video Bandwidth
Transmitter
Input Ports
Output Ports
Receiver
Input Ports
Output Ports
CAT5e/6/7 Cable
Distance
300 MHz/10.2 Gbps
1×HDMI, 1×IR Extender, 1×RS-232
1×CAT5e/6/7, 1×IR Blaster
1×CAT5e/6/7, 1×IR Extender
1×HDMI, 1×IR Blaster, 1×RS-232
Up to 60 m
HDMI Input Cable
Distance
HDMI Output Cable
Distance
ESD Protection
10 m@8-bit, 6 m@12-bit
10 m@8-bit, 6 m@12-bit
Power Supply
Human Body Model:
±8 kV (air-gap discharge)
±4 kV (contact discharge)
24 V/1.25 A DC (US/EU standards, CE/
FCC/UL certified)
Dimensions
Weight
Chassis Material
Silkscreen Color
71 mm (W)×79 mm(D)×23 mm (H)/Each
120 g/TX, 126 g/RX
Metal
Black
Operating Temperature 0 ˚C ~ 40 ˚C / 32 ˚F ~ 104 ˚F
Storage Temperature
Relative Humidity
Power Consumption
−20 ˚C ~ 60 ˚C / −4 ˚F ~ 140 ˚F
20 ~ 90% RH (non-condensing)
3 W/TX, 6 W/RX
8
CAT5e/6/7 Cable Specification:
LENGTH BANDWIDTH DATA RATE SUPPORTED VIDEO
Up to
60 m
Up to
225 MHz
Up to
5.3 Gbps
HD Video
Up to 1080p@60 Hz/36-bit, 3D
(data rate lower than 5.3 Gbps or bandwidth below 225 MHz).
Up to
35 m
Greater than
225 MHz
Greater than
5.3 Gbps
Ultra HD Video
Up to 4K×2K@30 Hz.
9. ACRONYMS
ACRONYM
CAT5e
CAT6
CAT7
CEC
DVI
HDCP
HDMI
IR
PoE
COMPLETE TERM
Category 5 Cable
Category 6 Cable
Category 7 Cable
Consumer Electronics Control
Digital Visual Interface
High-bandwidth Digital Content Protection
High-Definition multimedia Interface
Infrared
Power over Ethernet
9
CYPRESS TECHNOLOGY CO., LTD
Home page: http://www.cypress.com.tw
advertisement
Related manuals
advertisement