6.2 Receiver Front and Rear Panels. CYP CH-506RXPL, CH-506TXPL, CHDBX-1C
Add to My manuals16 Pages
CYP CH-506TXPL is a compact and powerful HDBaseT™ Lite HDMI extender set that allows you to transmit uncompressed 1080p video and audio signals, along with IR and RS-232 control signals, over a single CAT5e/6/7 cable up to 60 meters (197 feet). It supports HDMI including 3D and 4k×2k (Ultra HD) content, HDCP, and DVI compliance. With built-in IR and RS-232 ports, you can easily control your HDMI source and display devices from a remote location.
advertisement
6.2 Receiver Front and Rear Panels
Front
IR1 Extender
HDMI Out
RS232 Out IR2 Blaster
6
Rear
Power
Link
Lite
1 2 3 4 5
CAT 5e /6 In
7
1 RS232 Out: Connect to the device that is to be controlled (with the supplied 3.5mm mini-jack to D-sub 9-pin adaptor) by RS-232 commands
2 IR1 Extender: Connect an IR extender cable for IR signal reception.
Ensure that the remote being used is within the direct line-of-sight of the IR extender.
3 IR2 Blaster: Connect an IR blaster cable for IR signal transmission.
Place the IR blaster in direct line of sight of the equipment to be controlled.
4 HDMI Out: Connect to a HDMI equipped TV/monitor for display of the HDMI input source signal.
5 Link LED: This yellow LED will illuminate when both the input and output CAT5e/6/7 signals are connected. The LED will blink when there is an error with the transmission signal.
6 Power LED: This green LED will illuminate when the device is connected to a power supply.
7 CAT5e/6 In: Connect to the transmitter unit with a Single CAT5e/6/7 cable for transmission of all data signals.
4
advertisement