Tech Lighting Brim Head Instructions

Installation Instructions for

Brim Head

700 FJBRM _

920FJBRIM

1.0

H EADS -L OW V OLTAGE

G P I :

This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor.

C AUTION: To reduce the risk of a burn or electric shock during accessory installation, disconnect the power to the fixture.

Adjust the Fixture

1A

Lenses and Optics (Optional)

2A

FIXTURE

HEAD

1 Tilt the fixture head to the desired position.

COVER

1

NOTE: While installing or replacing lens and/or optics, it is recommended to do so with the fixture head facing downward to hold items in place within the cover during installation.

1 If installing or replacing lens accessory or replacing the optic, remove the cover by unscrewing it from the fixture.

2B

FIXTURE HEAD

OPTIC

LENS ACCESSORY

COVER

2 Remove the optic.

3 If installing an optional lens, rest the lens inside the cover. NOTE: A maximum of two lenses can be installed.

4 Install the optic (replacement or existing) inside the LED housing cover.

5 Reinstall the cover (reversal of step 2A).

SAVE THESE INSTRUCTIONS!

2

7400 Linder Ave, Skokie, IL 60077

847.410.4400

www.techlighting.com

© 2016 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.

A Generation Brands Company